HP 8000f - Elite Ultra-slim Desktop PC Maintenance And Service Manual page 21

Table 3-4 Computer Setup—Security (continued)
Power-On Password Allows you to set and enable a power-on password. The power-on password prompt appears
after a power cycle. If the user does not enter the correct power-on password, the unit will not
boot.
NOTE:
from Windows, unless enabled in Password Options (see below).
See the Desktop Management Guide for more information.
Password Options Allows you to enable/disable:
●
(This selection appears
only if a power-on
●
password or setup
password is set.)
●
●
●
●
See the Desktop Management Guide for more information.
Smart Cover (some Allows you to:
models)
●
●
NOTE:
removed. Setup Password requires that the setup password be entered to boot the computer if
the sensor detects that the cover has been removed.
This feature is supported on some models only. See the Desktop Management Guide for more
information.
Device Security Allows you to set Device Available/Device Hidden for:
●
●
●
●
●
●
●
●
●
●
This password does not appear on warm boots , such as
Lock Legacy Resources (appears if a setup password is set)
Network Server Mode (appears if a power-on password is set)
Password Prompt on Warm Boot (Ctrl+Alt+Delete) (appears if a power-on password is set)
Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
the F10 Setup Options without entering setup password)
Stringent Password (appears if a power-on password is set), which when enabled bypasses
the onboard password jumper to disable the power-on password.
Password prompt on F9, F11, & F12 (allows access to menus without entering setup
password)
Lock/unlock the Cover Lock.
Set the Cover Removal Sensor to Disable/Notify User/Setup Password.
Notify User alerts the user that the sensor has detected that the cover has been
Serial ports
Parallel port
System audio
Network controllers (some models)
Embedded security device (some models)
SATA0
SATA1 (some models)
SATA2 (some models)
SATA3 (some models)
eSATA (some models)
Ctrl+Alt+Delete or Restart
Computer Setup (F10) Utilities 11