Fuji Electric DeviceNet OPC-VG1-DEV Instruction Manual
Fuji Electric DeviceNet OPC-VG1-DEV Instruction Manual

Fuji Electric DeviceNet OPC-VG1-DEV Instruction Manual

Devicenet interface card for frenic-vg

Advertisement

FRENIC- - - - VG VG VG VG 用 用 用 用
FRENIC
FRENIC
FRENIC
本オプションは次のインバータソフトウェアバージョンに対応しています。
当社高性能ベクトル制御形インバータ FREN
きありがとうございます。
- 間違った取扱いは,正常な運転を妨げ,寿命の低下や故障の原因になります。
- この取扱説明書は,実際に使用される最終需要家に確実にお届けください。
- この取扱説明書は,DeviceNet インタフェースカードが廃棄されるまで大切に保管してください。
- この取扱説明書には機能コードの説明やトラブルシューティングの記載はありませんので,FRENIC-VG ユーザ
ーズマニュアルを合わせてご覧ください。
DeviceNet インタフェース
DeviceNet
DeviceNet
DeviceNet
インタフェースカード
インタフェース
インタフェース
OPC-VG1-DEV
VG1 インバータ本体 ROM
H10030 以降,H20030 以降
FRENIC IC IC IC- - - - VG VG VG VG シリーズ用 DeviceNet インタフェースカードをお買上げいただ
FREN
FREN
カード
カード
カード
- 1 -
INR-SI47-1661-JE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DeviceNet OPC-VG1-DEV and is the answer not in the manual?

Questions and answers

Summary of Contents for Fuji Electric DeviceNet OPC-VG1-DEV

  • Page 1 DeviceNet DeviceNet インタフェース DeviceNet DeviceNet インタフェース インタフェース インタフェースカード カード カード カード FRENIC FRENIC FRENIC FRENIC- - - - VG VG VG VG 用 用 用 用 OPC-VG1-DEV 本オプションは次のインバータソフトウェアバージョンに対応しています。 VG1 インバータ本体 ROM H10030 以降,H20030 以降 当社高性能ベクトル制御形インバータ FREN FREN FREN FRENIC IC IC IC- - - - VG VG VG VG シリーズ用 DeviceNet インタフェースカードをお買上げいただ きありがとうございます。...
  • Page 2 まえがき まえがき まえがき まえがき DeviceNet インタフェースカード「OPC-VG1-DEV」をお買上げいただきましてありがとうございます。 DeviceNet マスタ機器(各社 PLC の DeviceNet マスタユニット)により、 DeviceNet 経由で FRENIC-VG をコントロール するときに本カードを使用します。 本カードの特徴は以下のとおりです。 - FRENIC5000VG7 シリーズと互換 - DeviceNet 仕様書 Volume1 3.12 および Volume3 1.12 対応 (コンフォーマンステストリビジョン CT24 合格) - インバータ共通フォーマット AC Drive プロファイル対応 - 運転,停止などの指令入力 - 速度指令の設定:16 ビットバイナリデータ...
  • Page 3 取付 取付 取付 取付けおよび けおよび けおよび配線 けおよび 配線 配線について 配線 について について について ・ インバータの電源 電源を を を を 遮断 遮断し し し し 22kW 22kW 以下 以下は は は は 5 5 5 5 分以上 分以上, , , , 30kW 30kW 以上...
  • Page 4 その その その その他 他 他 他 ・ 改造は絶対しないでください。 感電 感電 感電 感電, , , , けがのおそれあり けがのおそれあり けがのおそれあり けがのおそれあり 第 第 第 第 1 1 1 1 章 章 章 章 ご ご ご ご 使用 使用の の の の 前 前 前 前 に に に に 使用...
  • Page 5 1.3 使用上 使用上 使用上 使用上の の の の 注意 注意 注意 注意 1.3.1 1.3.1 1.3.1 1.3.1 一時保管 一時保管 一時保管 一時保管 表 表 表 表 1.3 1.3- - - - 1 1 1 1 保管 保管 保管, , , , 輸送時 保管...
  • Page 6 第 第 第 第 2 2 2 2 章 章 章 章 インタフェースカード インタフェースカードの の の の 取付 取付け け け け インタフェースカード インタフェースカード 取付 取付 2.1 前 前 前 前 カバー カバーの の の の 取外 取外し し し し カバー...
  • Page 7 2.2 インタフェースカード インタフェースカード インタフェースカード インタフェースカードの の の の 取付 取付 取付 取付け け け け 本インタフェースカードは,制御プリント基板上にあるコネクタ C-port に接続します。 取 取 取 取 付 付 付 付 け け け け 方法 方法 方法 方法 (1) 制御プリント基板のオプション取付け用金具の 1 ヵ所"a"に,付属のスペーサ"b"(1 本)を取り付けます。 (2) 本インタフェースカードのコネクタ(CN1)が制御プリント基板のコネクタ(C-port)に接続するように,インタフ ェースカードを取り付けます。...
  • Page 9 - Deliver this manual to the end user of this product. Keep this manual in a safe place until this product is discarded. - This manual does not contain the description of function codes or troubleshooting information. Read through this manual in conjunction with the FRENIC-VG User's Manual. Fuji Electric Co., Ltd. INR-SI47-1661-JE - 1 -...
  • Page 10: Safety Precautions

    Preface Thank you for purchasing our DeviceNet interface card "OPC-VG1-DEV." This card is used to control the FRENIC-VG from a DeviceNet master (e.g., PLCs of various manufacturers) via DeviceNet. This card has the following features. - Compatible with the FRENIC5000VG7 series - Compliant with the DeviceNet Specifications Volume 1 Release 3.12 and Volume 3 Release 1.12 (Passed conformance test revision CT24) - Supporting the inverter common format, AC Drive Profile...
  • Page 11 Installation and wiring • Before starting installation and wiring, turn OFF the power and wait at least five minutes for inverters of 22 kW or below, or at least ten minutes for those of 30 kW or above. Make sure that the LED monitor and charging lamp are turned OFF.
  • Page 12: Acceptance Inspection

    Disposal • Treat the interface card as an industrial waste when disposing of it. Otherwise injuries could occur. Others • Never modify the interface card. Doing so could cause an electric shock or injuries. Chaper 1 BEFORE USE 1.1 Acceptance Inspection •...
  • Page 13: Long Term Storage

    1.3 Precautions for Use 1.3.1 Temporary storage Table 1.3-1 Storage and Transport Environments Item Specifications Storage temperature -25 to +70˚C Places not subjected to abrupt temperature changes or condensation (Note 1) or freezing. Relative humidity 5 to 95% (Note 2) The interface card must not be exposed to dust, direct sunlight, corrosive or flammable Atmosphere gases, oil mist, vapor, water drops or vibration.
  • Page 14: Removing The Front Cover

    Chaper 2 INSTALLING THE INTERFACE CARD 2.1 Removing the Front Cover • Incorrect handling in installation/removal jobs could result in a broken produce. • Before installing or removing the interface card, shut down the input power to the inverter and make sure that the charging lamp is turned OFF.
  • Page 15: Installing The Interface Card

    DeviceNet interface card. Please feel free to send your comments regarding any errors or omissions you may have found, or any suggestions you may have for generally improving the manual. In no event will Fuji Electric Co., Ltd. be liable for any direct or indirect damages resulting from the application of the information in this manual.

Table of Contents