Table of Contents
Advertisement
5.1.4
ASUS CrashFree BIOS 2 utility
The ASUS CrashFree BIOS 2 is an auto recovery tool that allows you to restore
the BIOS file when it fails or gets corrupted during the updating process. You can
update a corrupted BIOS file using the motherboard support CD, or the floppy disk
that contains the updated BIOS file.
•
•
Recovering the BIOS from a floppy disk
To recover the BIOS from a floppy disk:
1.
Turn on the system.
2.
Insert the floppy disk with the original or updated BIOS file to the floppy disk
drive.
3.
The utility displays the following message and automatically checks the
floppy disk for the original or updated BIOS file.
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
If your display monitor is connected to the onboard VGA connector, the display
monitor will turn-off and the system will beep once while the CrashFree BIOS 2
starts updating your system. The system will beep once again while the process
is finished, and the display will return after the system restarts.
When found, the utility reads the BIOS file and starts flashing the corrupted
BIOS file.
Bad BIOS checksum. Starting BIOS recovery...
Checking for floppy...
Floppy found!
Reading file "VP5945GC.ROM". Completed.
Start flashing...
DO NOT shut down or reset the system while updating the BIOS! Doing so can
cause system boot failure!
4.
Restart the system after the utility completes the updating process.
5-
Prepare the motherboard support CD, or the floppy disk containing the
updated motherboard BIOS before using this utility.
Make sure that you rename the original or updated BIOS file in the floppy
disk to VP5945GC.ROM.
Chapter 5: BIOS setup
Advertisement
Table of Contents
