Intrusion Connector - Asus P3-P5G43 User Manual

7. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default , the pin labeled "Chassis Signal" and " Ground" are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.

Intrusion Connector

8. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC'97 audio standard.
Front Panel Audio Connector
•
•
3-10
We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard's high-definition audio
capability.
By default, this connector is set to HD Audio. If you want to connect a High
Definition front panel audio module to this connector, set the Front Panel
Support Type item in the BIOS to [HD Audio]. See section "4.4.3 Chipset"
for details.
CHASSIS
(Default)
AAFP
HD-audio-compliant
compliant definition
pin definition
Chapter 3: Motherboard info
Legacy AC'97