Barska AX12616 User Manual

User's Manual For Keypad Safe
Read all instructions before using this safe.
WARNING
- New safe is in factory default mode. Factory Pin
Code is "159"
- Follow manual to set and test your personal
pin code.
- Replace the cap on the Initialization Button after Pin
Code Registration
- Avoid leaving safe door open and unattended; it will
allow unauthorized individuals to reprogram the safe,
gaining full access to the safe and its contents.
- Test Emergency Keys and store them in a secure
place, NOT inside of the safe.
- To maximize security and performance of the safe,
test pin code every 6 months.
PARTS OF THE SAFE
B
A
Inside of Safe Door
Actual model may vary
A. Knob E. Bolts
B. Emergency Key Access F. Battery Compartment
C. Indicator Lights G. Initialization Button
D. Key Pad
OPEN SAFE WITH EMERGENCY KEY
1. Remove round cap, and insert Emergency Key.
2. Turn Emergency Key counter clockwise and turn the
Door Knob clockwise to open the safe.
INSTALL BATTERIES
1. Remove battery compartment cover.
2. Insert 4 AA batteries and restore battery cover.
Note: Do not mix old and new batteries
PIN CODE REGISTRATION
Safe retains 1 pin code
Factory default pin code is: "159"
1. Initialization Button is located inside of battery
compartment. Please pull out the battery
compartment cover until you see the button. Then
press and release the initialization button. Indicator
light under proceed should light up.
2. Enter desired 3-8 digit Pin Code and press "#"
key. Indicator light under proceed should disappear.
Replace cap on the initialization button.
TEST REGISTERED PIN CODE
1. With safe door open, extend the bolts by turning the
door knob counterclockwise.
C
D 2. Enter Registered Pin Code and press " " key.
Turn door knob clockwise.
Successful Registration
If you were able to turn the door knob with your
registered pin code then registration was successful.
Unsuccessful Registration
If you were NOT able to turn the door knob with your
registered pin code then registration was unsuccessful.
Please follow Pin Code Registration again to register
your desired pin code.
G
F
E
©2024 BARSKA® | Pomona, CA 91767 | www.barska.com
OPEN / CLOSE DOOR
Open
Enter registered Pin Code and press " " button. Turn
handle clockwise and open the door.
Close
Door: Close the door and turn handle counterclockwise.
Note: If 3 wrong Pin Codes are entered safe will activate
alarm for 20 seconds and safe will be inoperable.
Another 3 continuous wrong entries and alarm will
activate for 5 min and safe will be inoperable.
SOUND OPTION
Sound On
Press " 66#"
Sound Off
Press " 633#"
Note: Door alarm will Not sound in Silent Mode.
LOW BATTERY WARNING
When safe is low on battery, low battery indicator light
will light up. Follow steps under Install Batteries to install
batteries.
CARE AND MAINTENANCE
- Keep liquids away from the control panel. Spills on the
control panel will cause damage and possibly
electric shock.
- Secure safe in a proper area to prevent from falling and
causing damage or injury.
- DO NOT disassemble the product. For all repairs,
contact BARSKA Customer Service.
- DO NOT use chemicals or cleaning agents to clean
the safe.
See reverse side for more information