Barska AX12672 User Manual

User's Manual for
Keypad Fireproof Jewelry Safe
Read all instructions before using this safe
WARNING
- For security purposes, change the factory default code as
soon as possible. Factory default code is 123456.
- Test registered pin code a few times before closing the
safe door.
- Avoid leaving door open and unattended; it will allow
unauthorized individuals to reprogram the safe, gaining full
access to the safe and its contents.
- Do NOT store combustible materials in this unit.
- In the event of a fire, we recommend caution when opening
the safe. If you feel unsure about opening the safe because
of the contents stored, contact your local fire department
for assistance.
- Test the emergency keys and store then in a secure place;
NOT inside of the safe.
- Test and make sure the safe works properly
before mounting.
- Mount the safe before use, the safe may tip forward if not
properly mounted.
- Keep children away from safe; they should not play with or
around the safe at anytime. Children at play could
accidentally get locked inside the safe or accidentally pull on
the safe door causing safe to tip over if not properly mounted.
- Failure to follow these warnings could result in serious injury
or death.
NOTE: BARSKA is not responsible for any damage or lost
contents in the safe due to moisture.
NOTE: BARSKA is not responsible if the safe and its contents
gets lost or stolen.
© 2023 BARSKA®
855 Towne Center Drive | Pomona, CA 91767
(t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
PARTS OF THE SAFE
C
D
E
G H
F
*Actual model may vary
F. Keypad and Keypad Cover
A. Bolts
- turn keypad counter clock
B. Key Hook
wise to expose Battery
C. Reset Button
Compartment and
D. Motion Sensor Light
Emergency Key Access
E. Jewelry Drawer
G. Indicator Lights
H. Handle
BATTERY & KEY ACCESS
*To operate the safe, please
install one 9V Alkaline battery
(not included).
Push down on button located
under the key pad and turn
keypad cover counter
clockwise.
DO NOT pull on the wires or
touch the electronic
components.
Install Battery
Insert one new 9V alkaline battery into the battery
compartment and restore keypad cover.
Key Access
Insert access key into key slot and turn clockwise to open
safe.
MOTION SENSOR LIGHT
1. Motion Sensor Light has Velcro and magnet bar at rear, so it
can attach on the interior carpeted or metal surface of the safe.
Before you start to use the safe, please remove the light from
B
the safe and install with 4 AAA batteries (not included).
A
2. Motion Sensor Light should be automatically activated when
the safe door is opened each time. If not, please wave your
hand to activate the light. Light should turn off within a delay
time after the safe door is closed.
PIN CODE REGISTRATION
Safe retains 1 pin code (3 to 8 digits) Safe Factory Default PIN
Code :123456
Changing PIN Code
1. Insert original PIN code (for 1st time use, the original PIN code
is default PIN code)and press "#". Then, the green light will
turn on.
2. During the duration of green light on, press "*" and then the
yellow light will turn on as well. You can change to your desired
PIN code now.
NOTE: If you don't take any action after 8 seconds, the safe
will be back to standby mode.
3. Enter your desired PIN code and press "*". You will hear two
beeps and the yellow light will turn off. This means you have
registered your PIN code successfully.
NOTE: If you hear 4 beeps, it means you didn't register your
PIN code successfully. Please, repeat the above steps again.
See reverse side for more information
8/23
BC776