Pci Configuration - Dell PowerEdge C6100 Hardware Owner's Manual

Option
USB 2.0 Controller Mode
(HiSpeed default)
BIOS EHCI Hand-Off
(Enabled default)
USB Mass Storage Reset
Delay (20 sec default)
Device#
Emulation Type
(Auto default)

PCI Configuration

Option
NIC Function Support (PXE
default)
NIC1 Option ROM (Enable
default)
NIC2 Option ROM (Enable
default)
44
Using the System Setup Program
Description
Configures the USB 2.0 controller in HiSpeed
(480 Mbps) or FullSpeed (12 Mbps).
This is a work around for operating systems without
EHCI handoff support. The EHCI ownership change
should be claimed by EHCI driver.
The number of seconds that the POST waits for the
USB mass storage device after the start Unit
command is issued.
USB device model name
If Auto, USB devices, which are less than 530 MB are
emulated as floppy and others are be emulated as
hard disk. Forced FDD option can be used to force a
formatted hard drive to boot as FDD (e.g. ZIP drive)
Description
NIC Function Disable or PXE/iSCSI Support
Set OnBoard 82576EB Disable/Enable Option ROM
Set OnBoard 82576EB Disable/Enable Option ROM