Resetting Your Player; Specifications; System And Outputs; General - Dynex DX-UPDVD2 User Manual

Specifications

Cleaning discs
Fingerprints and dust on the disc can cause poor picture quality and
sound distortion. Before playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol, benzine, thinner,
commercially available cleaners, or anti-static spray intended for older
vinyl records.
Note: Never operate this player immediately after moving it from a cold
location to a warm location. Leave it for two or three hours without
operating it. If you use this product in such a situation, it may damage
discs or internal parts.

Resetting your player

Reset your player if you observe any of the following symptoms:
• Your player is plugged in, but the power will not turn on or
off.
• The display window is not working.
• Your player does not operate normally.
To reset your player:
• Unplug the power cord for 30 minutes, then plug in the
power cord again.
Specifications

System and outputs

VF Signal system NTSC
Frequency response CD: 20 Hz~20 KHz (EIAJ)
DVD: 20 Hz~44 KHz (96 KHz)(Sample result)
20 Hz~22 KHz (48 KHz)(Sample result)
Audio S/N ratio > 90 dB
Audio MPEG LAYER2 standard
Electric level output: 1.8 ± 0.2 V
Audio output (analog
audio) Resistance: 10 Kohm
Audio output (digital Electric level output: 0.5 V p-p
Resistance: 75 ohm
audio)
Electric level output: (1.0 ± 0.2) V p-p
Composite video
output Resistance: 75 ohm
Unbalanced negative
Component video (Y, Electric level output: 0.7 V p-p
Cb, Cr) Resistance: 75 ohm

General

Power 110~120 V 50/60 Hz
Power consumption 12 W
Dimensions (LxWxH) 14.173 x 8.267 x 1.3 inches
(359.99 x 209.98 x 33.02 mm)
Weight 4.08 lbs. (1.86 kg)
Operating 41°F to 95°F (5°C to 35°C)
temperature
Operating humidity 5% to 90%

Legal notices

FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this product is subject
to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply within the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC warning
Changes or modifications not expressly approved by the party responsible for
compliance with the FCC Rules could void the user's authority to operate this
equipment.
Notices
Specifications and features are subject to change without notice or obligation.
For service and support call (800) 305-2204.
11
DX-UPDVD2