Dynex DX-P7DVD11 User Manual page 7

DX-P7DVD11 and DX-P9DVD11
To connect to AC power:
1 Plug one end of the AC power adapter into the DC IN jack on the side of your player.
2 Plug the other end of the adapter into an AC wall outlet.
Charging and using the built-in battery
Your DVD player has a built-in, non-replaceable, rechargeable battery. Charge the built-in
battery before using it for the first time. Complete charging typically takes approximately 4-5
hours. The charging light goes out when the built-in battery is fully charged.
Warnings:
Notes:
To charge and use the built-in battery:
1 Turn off the player. The battery charges only when the player is turned off.
2 Connect the supplied AC power adapter to the DC IN jack on the player, then plug the
adapter into an AC power outlet.
When the battery is charging, the battery charge indicator lights red. When the
battery is fully charged, the charge light turns off.
3 Unplug the AC power adapter when the battery is fully charged, then you can use your
player with the built-in battery.
• When the AC power adapter is plugged in, the apparatus is not completely
disconnected from the main power supply, even when the power is turned off.
• Batteries should not be exposed to excessive heat such as sunshine, fire, or the like.
• During playback, when the battery low icon
built-in battery power is low and your player should be recharged.
• While using the built-in battery, the ambient temperature should be 41°F (5°C) to
95°F (35°C).
• To get the longest service life of the built-in battery, charge at indoor-temperature.
• The built-in battery in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, heat above 212°F (100°C), or incinerate.
• The unit should not be exposed to excessive heat such as sunshine, fire, or the like.
• When discarding the unit, environmental problems must be considered and local rules
or laws governing the disposal of such products must be strictly followed.
appears on the screen , the
7