AETEK XE22-110-TX-V2 Quick Installation Manual

PACKAGE CONTENTS
* 1x Outdoor EPoC Adapter
* 1x Gray Rubber for 6~8mm coaxial cable
IMPORTANT:
1. Use CAT5e or CAT6 UTP/STP cables and RG6 coaxial cables.
2. Please avoid using low quality cables, which will seriously limit the cabling distance and power delivery.
3. Make sure the ventilation openings on the EPoC Adapter are not blocked.
INSTALLED LOCATION:
For further protection against water ingress and high temperature , it is recommended to locate the unit where possible:
• Horizontal installation
• Shaded from sunlight & rainfall
CONNECTION
C42-084-91-770
NOTE:
To disconnect a LAN cable, loosen the cable
gland and pull the cable against the socket
wall towards the side of the locking tab.
Distance/Power Chart
Length of Coaxial Cable
300m 33.32W
500m 23.9W
800m 11.81W
1000m 8.7W
1200m 8.36W
1200m ~ 2400m Data only (100Mbps)
LEDs
LAN Green ON
Green flash
OFF
PoE Yellow ON
OFF
PWR Green ON
LINK Green ON
XE22-110-TX-V2 Outdoor EPoC Adapter
* 1x Quick Installation Guide
* 1x Black Rubber for 4.5~6.5mm coaxial cable
XE11-110-RX-V2
LAN: Data is connection
LAN: Data is being transmitted or received.
No connection
PoE output to PD device
No PoE output to PD device
EPoC Adapter power status
Rx and Tx EPoC Adapter is connected.
Quick Installation Guide
1,200m(3,937ft)
XE22-110-TX-V2
PoE Budget : 8.3W@1,200m / 3,937ft over RG6
Total Camera bandwidth < 100Mbps
IMPORTANT:
NOTE:
The Outdoor EPoC Adapter & SD-301 Surge Protector must be
grounded using a ground wire between the ground screw and
earth ground.
XE22-110-TX-V2:
NOTE:
1. The numberts comply using RG6 coaxial cables.
2. The length of network cable for camera connection is 1m CAT5e
cable.
3. The power delivery will vary on the quality of coaxial cable due to
resistance.
P/N: 5019056800
PoE
Camera
PoE (Data + Power)
Coax (Data + Power)
Ground screw