Dell 5100MP Owner's Manual page 24

Source
4
Keystone adjustment
5
Enter
6
Auto adjust
7
LCD status display
8
TEMP warning light
9
10 LAMP warning light
and buttons
11
12 Keystone adjustment
13 Up
and
14 Brightness and contrast
control
24 Using Your Projector
Press to toggle through S-video, Composite
Video, M1-D, D-sub, BNC, Component, HDMI
and M1 sources when multiple sources are
connected to the projector.
Press to adjust image distortion caused by tilting
the projector. (±20 degrees)
Press to confirm the selection item.
Press to synchronize the projector to the input
source.
Auto adjust does not operate if the on-screen
display (OSD) is displayed.
LCD display is for real time projector status.
• If the TEMP light is solid orange, the projector
has overheated. The display automatically shuts
down. Turn the display on again after the
projector cools down. If the problem persists,
contact Dell.
• If the TEMP light is blinking orange, a projector
fan has failed and the projector automatically
shuts down. If the problem persists, contact
Dell.
If the LAMP light is solid orange, replace the
lamp.
Press to adjust the OSD setting.
Press to adjust image distortion caused by tilting
the projector. (±20 degrees)
Down Press to select the OSD items.
Press to control brightness and contrast, press
or to adjust brightness or contrast, then press
and buttons to adjust the value.