Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. PRODUCT DESCRIPTION................6 4. TECHNICAL DATA..................8 5.
the use of the appliance in a safe way and understand the hazards involved. • Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. •...
• The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering. • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre.
2.4 Use • Always use a correctly installed shockproof socket. • Make sure that the parameters on the WARNING! rating plate are compatible with the Risk of injury, electric shock, fire, burns electrical ratings of the mains power or damage to the appliance. supply.
repairers, and that not all spare parts are • Disconnect the appliance from the mains relevant for all models. electrical and water supplies. • Concerning the lamp(s) inside this product • Cut off the mains electrical cable close to and spare part lamps sold separately: the appliance and dispose of it.
Access your appliance details, documentation and articles on how to use the best features (User Manual also available at electrolux.com/manuals ) • Get usage advice, troubleshooting, service and repair information (also available at electrolux.com/ support ) • Buy accessories, Consumable and Original Spare parts for you appliance (also available at electrolux.com/shop )
4. TECHNICAL DATA Dimension Width/ Height/ Total depth 59.7 cm /84.7 cm /63.6 cm Electrical connection Voltage 230 V Overall power 2100 W Fuse 10 A Frequency 50 Hz Level of protection against ingress of solid particles and moisture ensured IPX4 by the protective cover, except where the low voltage equipment has no protection against moisture...
WARNING! It is possible to see water flowing Do not put cardboard, wood or equivalent from the drain hose. This is because materials below the appliance feet to the washing machine has been adjust the level. tested at the factory. The inlet hose 4.
Page 10
WARNING! The inlet water shall not exceed 25 °C. Water drainage 3/4” The drain hose should stay at a height of no less than 60 cm and not more than 100 cm. You can extend the drain hose to 3/4” maximum 400 cm.
sink - Fasten the guide to the water tap or to ratings. Make sure that they are compatible the wall. with the mains power supply. Check that your domestic electrical installation can take the maximum load Make sure that the plastic guide cannot required, also taking into account any other move when the appliance drains and the appliances may also be in use.
Page 12
The options are not selectable with all washing programmes. Check the compatibility between options and washing programmes in the "Options compatibility with programmes" paragraph in the "Programmes" chapter. An option can exclude another one, in this case the appliance doesn't allow you to set the incompatible options together. Make sure the screen and touch buttons are always clean and dry.
The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. • Cycle end ( • Warning code (e.g. • Error indicator ( • When working with the APP: (access point), (update). Please refer to the chapter 'Wi-FI - Connectivity setup'. •...
7.3 Programme dial 7.6 Prewash By rotating the programme dial it is possible With this option you can add a prewash to select the desired programme. phase to a washing programme. The corresponding indicator above the touch 7.4 Temperature button illuminates. When you select a washing programme, the Use this option to add a pre-wash phase at appliance automatically proposes a default...
7.9 Steam Easy Iron As the programme is very quiet, it is suitable for use at night time when cheaper electricity This option adds a steam phase followed by a tariffs are available. In some programmes the short anti-crease phase at the end of the rinses are performed with more water.
This phase reduces fabric creasing and the shortest cycle to freshen up a small facilitates the fabric ironing. amount of laundry. The Time Manager is available only with the When this option is set the icon lits on the programmes in the table. display, the led above the button is on and then blinks during anti-crease phase.
• The programme is completed (sequence 1. Switch the appliance on by pressing the of sounds for about 2 minutes). On/Off button. • The appliance has a malfunction 2. Press and hold the Stains and Extra (sequence of short sounds for about 5 Rinse buttons for some seconds.
10. PROGRAMMES 10.1 The app and additional hidden programmes Our app provides you with a wide choice of additional hidden programmes. Connect the appliance to App and you will be able to choose the programme that suits your needs most. Programme names are subject to change depending on market requirements without notice.
Page 19
Items with label "Dry clean only". Electrolux fragrance. If you use this special gentle fragrance, your laundry will scent as just washed. Read care‐ fully the instructions supplied with the fragrance. Reduce the fragrance dosage when treating smaller load. By means of the Time Manager button, you can reduce the programme duration when treating items labeled to be washed at low temperature.
Page 20
Programme Programme description Outdoor Do not use fabric softener and make sure that there is no softener residue in the detergent dispenser. Outdoor clothing, technical, sport fabrics, waterproof and breathable jackets, shell jackets with a removable fleece or inner insulation. The recommended laundry load is 2.0 kg.
Page 21
Programme Default tempera‐ Reference spin speed Maximum load ture Spin speed range Temperature range 30 °C 1200 rpm 5.0 kg 60 °C - Cold 1200 rpm - 400 rpm Synthetics 30 °C 800 rpm 2.0 kg 40 °C - Cold 1200 rpm - 400 rpm Delicates 40 °C...
Page 22
10.3 Woolmark Wool Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments la‐ belled as «hand wash» provided that the products are washed according to the instructions on the garment label and those issued by the manufacturer of this washing machine.
Delay Start ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ If you set the No Spin option, the appliance performs draining only. This option is not available with temperature lower than 40 °C. Stains and Prewash cannot be selected together. If you set the shortest duration, we recommend that you decrease the load size.
Page 24
11.2 Installing and configuring App • Mobile device connected to wireless network. Wi-Fi module parameters App allows you to control your laundry through a mobile device. Frequency 2.412 - 2.472 GHz for Europe‐ an market It contains a large number of programmes, useful features and product Protocol IEEE 802.11b/g/n...
To switch the wireless connection off, Release the buttons. appears on the after the connectivity is configured, press display for 5 seconds and the indicator and hold the Time Manager and the Delay starts blinking. Start buttons simultaneously for a few The wireless module begins starting up.
The update is accepted via App only. The indicators appear on the programme summary screen and the door is If a programme is running, the App notifies locked. Now it is possible to start the that the update will start at the end of the programme remotely.
12.3 Filling the detergent and 2. Press the lever down to remove the additives dispenser. 3. To use powder detergent, turn the flap Compartment for prewash phase, soak programme or stain remover. Compartment for washing phase. Compartment for liquid additives (fabric conditioner, starch).
5. Measure out the detergent and the fabric 2. To change the temperature and/or the conditioner. spin speed, touch the related buttons. 6. Carefully close the detergent dispenser. 3. If desired, set one or more options by touching the related buttons. The related indicators come on in the display and the given information changes accordingly.
will be not possible to guarantee the best Changing the delay start after the washing results. countdown has started To change the delay start: About 20 minutes after the programme 1. Touch the Start/Pause button to start, the programme duration could be pause the appliance.
signals operate (if they are active). The display shows If the SensiCare phase is already carried out and the water filling is already The indicator of the Start/Pause button started, the new programme starts goes off. without repeating the SensiCare phase.
Press the On/Off button to activate the appliance again. The display shows the end of the last If you have set Silent and the spin programme. speed is not changed, when you press Turn the programme dial to set a new the Start/Pause button, the appliance cycle.
– powder detergents (also tablets and single-dose detergents) for all types of fabric, excluding delicate. Prefer powder detergents containing bleach for whites and laundry sanitization, – liquid detergents (also single-dose detergents) , preferably for low temperature wash programmes (60 °C max) for all types of fabric, or special ones for woollens only.
13.5 Water hardness helps to reduce energy and water consumption. If the water in your area is hard or medium • With adequate pre-treatment, stains and hard, we recommend that you use a water limited soiling can be removed; the softener for washing machines.
14.4 Descaling If the water in your area is hard or medium hard, we recommend that you use a water softener for washing machines. Regularly examine the drum to check for limescale. Clean it when needed, using ammonia cream The regular detergents already contain water cleanser agent without scratching the seal softening agents, but we recommend to run a surface.
4. Add a manually small quantity of powder detergent or a specific product into the empty drum, in order to rinse out any left residues. Occasionally, at the end of a cycle the display may show the icon : this is a recommendation to perform the “drum cleaning”.
Page 36
4. Turn the filter 180 degrees in anti- clockwise direction to open it, without removing. Let the water flow out. Regularly check the drain pump filter and make sure that it is clean. Clean the drain pump if: • The appliance does not drain the water. •...
14.10 Cleaning the inlet hose and 10. Clean the filter under the water tap. the valve filter It is recommended to clean both the filters of the inlet hose and valve occasionally to remove any deposit, collected over the time: 1.
14.12 Frost precautions If the appliance is installed in an area where the temperature can reach the values around 0° C or drop below, remove the remaining water from the inlet hose and the drain pump. 1. Disconnect the mains plug from the mains socket.
Page 39
With some problems, the display shows an alarm code and the Start/ Pause button may flash continuously: If the appliance is overloaded, remove some items from the drum and/or keep pressed the door while touching the Start/Pause button until the indicator stops flashing (see the picture below).
Page 40
If the display shows other alarm codes, deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. In case of different problem with the appliance check the table below for possible solutions. Problem Possible solution • Make sure that the mains plug is connected to the mains socket.
Page 41
Problem Possible solution • Check the wireless signal. • Check if your smart device is connected to the wireless network. • Check your home network and router. • Restart the router. The App cannot connect to • Contact your wireless service provider if there are problems with the wireless the appliance.
15.2 Emergency door opening To open the door, proceed as follows: 1. Press the On/Off button to switch the In case of power failure or functioning failure appliance off. the appliance door remains locked. The 2. Disconnect the mains plug from the washing programme continues when the mains socket.
Page 43
16.2 According to Commission Regulation Eu 2019/2023 Eco 40-60 pro‐ rpm 1) Litres hh:mm °C gramme Full load 10.0 0.700 69.0 03:58 52.00 31.0 1400 Half load 0.495 51.0 02:59 52.00 29.0 1400 Quarter load 0.225 34.0 02:50 54.00 23.0 1400 Maximum spin speed.
17. QUICK GUIDE 17.1 Daily use • Connect the mains plug to the mains • Pour the detergent and other treatment in socket. the proper compartment of the detergent • Open the water tap. dispenser. • Push the On/Off button to turn the •...
17.2 Cleaning the drain pump filter 180˚ Clean the filter regularly and, especially, if the alarm code appears on the display. 17.3 Programmes Programmes Load Product description Cotton and synthetic items. This programme ensures a good wash‐ ing performance in a short time. The standard program duration has been devel‐...
Programmes Load Product description 4.0 kg Denim clothing and jersey items. Jeans Synthetic or feather and down filled blankets, padded clothes, du‐ 3.0 kg vets. Duvet 2.0 kg Modern outdoor sporting garments. Outdoor 1.0 kg White cotton items. This programme removes more than 99,99% of 10.0 kg bacteria and viruses .
Page 48
The software in this product contains components that are based on free and open source software. Electrolux gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://electrolux.opensoftwarerepository.com (folder NIUS)
Need help?
Do you have a question about the EW7F410GY and is the answer not in the manual?
Questions and answers