Whirlpool 9761413 Installation Instructions Manual page 16

5. NOTE: Do not remove the spring beneath the cap.
A
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out
C. Gas pressure regulator cap with solid end facing out
D. Washer
E. Gas pressure regulator cap
6. Turn the gas pressure regulator cap over and reinstall on
regulator so that the solid end faces out and letter "N" is
visible.
7. Replace plastic cover over gas pressure regulator cap.
To Convert Standard Surface Burners
1. Remove burner cap.
®
2. Using a T20 TORX screwdriver, remove the burner base.
3. Apply masking tape to the end of a
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out, set gas orifice
spud aside.
A
B
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
4. Gas orifice spuds are stamped with a number on the side.
Replace the LP gas orifice spud with the correct Natural gas
orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement.
16
Side view before
B
D
E
N
C
Side view after
mm nut driver to help
C
D
A
Natural Gas Orifice Spud Chart for Standard Surface Burners
Burner Location Burner Rating
Right front 6,000 BTU
Left front 14,000 BTU
Right rear 12,500 BTU
Left rear 6,000 BTU
5. Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
6. Replace burner cap.
7. Repeat steps 1-6 for the remaining burners, except for the
TripleTier™ Flame burner (on some models). See "To Convert
TripleTier™ Flame Burners" section.
To Convert TripleTier™ Flame Burner (on some models)
1. Remove burner cap.
2. Remove the burner head using a size T20 TORX
3. Remove the plate on the external gas orifice spud.
A. Burner caps
B. Burner heads
C. External gas orifice spud access plate
D. Internal gas orifice spud
IMPORTANT: The TripleTier™ Flame burner has 2 gas orifice
spuds. Do not forget to change the external gas orifice spud
located under the plate.
A
B
C
A. Plate
B. External gas orfice spud
C. Internal gas orifice spud
4. Apply masking tape to the end of a
hold the internal gas orifice spud in the nut driver while
changing it. Press nut driver down onto the internal gas
orifice spud and remove by turning it counterclockwise and
lifting out. Set internal gas orifice spud aside.
Size
1.10 mm
1.70 mm
1.61 mm
1.10 mm
® screwdriver.
A
B
C
D
mm nut driver to help