Temperature Control; Features Of Your Iron - Morphy Richards IB40713 Manual

40715 Rev 1 31/5/05

Temperature control

Increase
temperature
Decrease
temperature
• Default setting + 3 dot (cotton)
• To increase temperature press the top
button.
• To decrease temperature press the
bottom button.
• The light panel will flash to indicate that
the iron has not yet reached the correct
temperature.
• Once the correct temperature has been
reached , the light will stop flashing and
there will be one 'beep' to signal that the
iron is now ready for use.

Features of your iron

Dry ironing
You can use your iron as a dry iron only.
Make sure the variable steam control ⁄ is
set to the '0' symbol.
Any temperature setting may be used
depending on the garment. The spray
feature may be used provided there is water
in the tank (see filling section). You do not
need to put any water in the tank when dry
ironing only.
9:11 AM Page 5
B
Spray
Press the spray button ‹
and aim the spray of water at
stubborn creases. You can do
this whilst dry ironing providing
there is water in the tank. When
using the water spray it may be
necessary to push the button a
few times to get the spray pump primed.
Variable steam
Fill the iron with water as described in
'Filling', page 4 and insert the plug into the
electrical socket.
The steam output can be varied from
low to high by turning the variable steam
control C. When using the iron at the
bottom of the steam range, the steam
output should be adjusted to the low
setting.
The steam facility should only be used
on garments which are suitable for ironing
at 2, 3 dot and MAX setting.
Steam off
'MAX' steam
5
C