Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mcombo 6055-4607
Summary of Contents for Mcombo 6055-4607
- Page 1 MANUAL RETRACTABLE AWNING 6055-4607&4627&4664 MCombo.com Amazon.com/mcombo...
-
Page 2: Table Of Contents
Please read, understand, and follow this user manual before assembling and using. You will not refuse or neglect any retrofit kits that MCombo may provide to enhance and preserve Save this manual for future reference. It's the responsibility of the user for potential risks of injuries due to inappropriate use not obeying safety instructions in this manual. -
Page 3: Safely Guidelines
I. Safely Guidelines II. Preparation • Before you start, check the condition and quantity of all parts according to the parts list. For your own safety, please strictly follow the instructlons in this WARNING manual, otherwise personal injury may result! Do not remove the safety wrapping that holds the awning arms WARNING in place. -
Page 4: Part List
III. Part List Fabric Part List Torsion Bar Fabric x1 Torsion Bar with Arm ( le� ) x1 Torsion Bar with Arm ( right ) x1 Torsion Bar Screw x2 Valance x1 Fabric Guiding Wire x3 Roller Other Accessories Roller ( le� ) x1 Le�... -
Page 5: Parts Exploded View
IV. Parts Exploded View V. Assembly Steps Part List Part List Fix left & right Torsion Bar with Arm (#A-1,#A-2) by Screws (#D). Connect left with right Roller (#B-1,#B-2) by Screws (#J). Pg / 07 Pg / 08... - Page 6 Install the Fabric. Connect left with right Front Bar (#C-1,#C-2) by Screws (#J). (1). Pass two sides of Fabric (#M) which wearing Guiding Wires (#N) through the slot of long round Roller and Front Bar. Cutting off excess threads. (2). Insert Fabric Plug (#K) respectively into two ends of Roller and Front Bar.
- Page 7 Slide the Arm Link (#F) into each end of Front Bar, then insert (#F) into holes in Torsion Bar. Sleeve rolled Roller from step 5 with Torsion Bar from step 1. Note: (1). If it is not good to slide in, you can loosen the two short screws a little. (2).
- Page 8 Mounting on the Wall: Put Plastic Cover (#G) on ends of Front Bar. (1). Drill holes in the wall with a 0.55 inches diameter drill bit, please pay attention to the deep of hole that should not be less than 4 inches. (2).
-
Page 9: Return / Replacement Policy
To initiate a return, please contact our customer service team at the hand crank handle. ( sales@mcombo.com / 1-323-597-1109 ) for any help. Return Conditions We accept the return of items that are in new, unused condition, with original tags attached and all original packaging and other components included. -
Page 10: Mcombo Customer Support
This Limited Warranty covers any defects in material or workmanship under normal use during (Respond within 24 hours) the Warranty Period. During the Warranty Period, MCombo will repair or replace, at no charge, products or parts of a product that proves defective because of improper material or workmanship,under normal 1-323-597-1109 use and maintenance.
Need help?
Do you have a question about the 6055-4607 and is the answer not in the manual?
Questions and answers