Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Mcombo 6055-4693
Summary of Contents for Mcombo 6055-4693
- Page 1 MOTORIZED AWNING Manual Version: 1.1.1 6055-4693 MCombo.com Amazon.com/mcombo...
-
Page 2: Table Of Contents
Please read, understand, and follow this user manual before assembling and using. You will not refuse or neglect any retrofit kits that MCombo may provide to enhance and preserve Save this manual for future reference. It's the responsibility of the user for potential risks of injuries due to inappropriate use not obeying safety instructions in this manual. -
Page 3: Safely Guidelines
I. Safely Guidelines II. Preparation • Before you start, check the condition and quantity of all parts according to the parts list. For your own safety, please strictly follow the instructlons in this WARNING manual, otherwise personal injury may result! Do not remove the safety wrapping that holds the awning arms WARNING in place. -
Page 4: Part List
III. Part List Fabric Part List Torsion Bar Fabric x1 Torsion Bar with Arm ( le� ) x1 Torsion Bar with Arm ( right ) x1 Torsion Bar Screw x2 Valance x1 Fabric Guiding Wire x3 Roller Other Accessories Roller ( le� ) x1 Le�... -
Page 5: Parts Exploded View
IV. Parts Exploded View V. Assembly Steps Part List Part List Fix left & right Torsion Bar with Arm (#A-1,#A-2) by Screws (#D). Connect left with right Roller (#B-1,#B-2) by Screws (#J). Pg / 07 Pg / 08... - Page 6 Install the Fabric. Connect left with right Front Bar (#C-1,#C-2) by Screws (#J). (1). Pass two sides of Fabric (#M) which wearing Guiding Wires (#N) through the slot of long round Roller and Front Bar. Cutting off excess threads. (2). Insert Fabric Plug (#K) respectively into two ends of Roller and Front Bar.
- Page 7 Slide the Arm Link (#F) into each end of Front Bar, then insert (#F) into holes in Torsion Bar. Put together rolled Roller from step 5 with Torsion Bar from step 1. Note: (1). If it is not good to slide in, you can loosen the two short screws a little. (2).
- Page 8 Mounting on the Wall: Put Plastic Cover (#G) on ends of Front Bar. (1). Drill holes in the wall with a 0.55 inches diameter drill bit, please pay attention to the deep of hole that should not be less than 4 inches. (2).
-
Page 9: About The Motor
Use of Awning. Adjusting Motor Travel Increasing the travel limit (1). Cutting the safety packaging of the curved Arm. Reducing the travel limit According to motor rotating direction, adjust the travel limit with the use of the 4mm hex wrench #Q-1. -
Page 10: Return / Replacement Policy
Please securely pack the item in its original packaging, including any accessories or manuals that came with the product. To initiate a return, please contact our customer service team at ( sales@mcombo.com / 1-323-597-1109 ) for any help. Return Conditions Tips: The motor and remote control are already coded and connected at the factory se�ng.
Need help?
Do you have a question about the 6055-4693 and is the answer not in the manual?
Questions and answers