Advertisement
Using Rechargeable Batteries
Your radio has a built-in power dynamo which can charge the internal
rechargeable battery pack and let you play your radio without the AA
batteries. When you rotate the crank handle for as little as 1
the dynamo recharges the Ni-MH battery which powers the radio for
approx. 30 minutes. Follow these steps to power your radio using dy-
namo and the rechargeable battery pack.
1 Remove the battery compartment cover.
2 The supplied Ni-MH battery is installed but not connected. Insert
the battery pack plug into the two pin battery pack socket. Replace
the compartment cover.
Caution: The battery pack's polarized plug fits into the socket only one
way. If the plug does not fit properly, turn it round and try again. Do not
force it into the socket.
3 Set DYNAMO/BATT switch to DYNAMO or BATT. Charging takes
place using either position.
4 Set On/Off/band selector switch to OFF.
5 Lift the crank handle and rotate it clockwise or counterclockwise.
Radio operation time depends on
the number of turns and the time
per turn. For example,
approximately 2 turns per
second for 90 seconds will
provide about 30 minutes of
radio operation at a medium
volume level. You can recharge
the battery pack even while the
radio plays.
6 Return the crank to the folded position.
Replace the Ni-MH battery when the play time reduces to an unaccept-
able level.
1 Remove the battery compartment cover.
2 Unplug the rechargeable battery pack connector and lift the pack
out of the compartment.
Specifications
BANDS
Frequency Range
Intermediate Frequency
GENERAL
Power Output
Power Requirement
Headphone Impedance
Speaker
Aerial
Dimensions (HxWxD)
Weight (without batteries)
WARNINGS
Do not expose this unit to direct sunlight or heat
radiating sources.
Make sure all batteries are inserted according
-
+
to the proper polarity. Do not mix old batteries
with new ones.
-
+
If the unit is not used for a long period of time
(more than 1 month), remove all batteries from
their compartment to avoid possible leaking.
Whilst using the earphones do not operate the
emergency alarm.
1
/
minutes,
2
5
MW 522 - 1620 kHz
FM 87.5 - 108 MHz
MW 465 kHz
FM 10.7 MHz
80 mW (maximum)
DC 3V (2 batteries UM-3/ AA)
DC 2.4V 1 rechargeable battery
8 Ohm
45 mm
Ferrite Bar aerial for MW
Telescopic aerial for FM
3 3/4 x 7 1/2 x 2 3/8 inches
96 x 190 x 61 mm
1 lb 5 oz (600 g)
7
! Insert a new battery pack plug into the socket and place the
battery into the compartment.
Caution:The supplied battery pack plug has the red wire toward the top
of the radio when inserted correctly. To ensure proper polarity, only use
the supplied or recommended replacement battery pack.
4 Replace the compartment cover.
OPERATION
PLAYING THE RADIO
1 Rotate DYNAMO/BATT switch to BATT if you have installed AA
batteries. To power the radio using the Ni-MH pack or the
generator, rotate DYNAMO/BATT switch to DYNAMO.
2 Set On/Off/band selector switch to the desired band.
3 Rotate TUNING control to select the desired station.
4 Adjust VOLUME control to a comfortable listening level.
5 To turn off the radio, set On/Off/band selector switch to OFF.
Using the display light
Hold down LIGHT to illuminate the dial in low-light conditions.
Using the emergency alarm
Press the EMERGENCY ALARM button. The radio sounds a loud,
repeating beep. Press EMERGENCY ALARM button again to stop the
alarm. Any broadcast stops temporarily when the beep sounds.
Note: The emergency alarm takes 4 to 5 seconds to start after the
button is pressed.
Using earphones
To listen to the radio privately, connect earphones with a 3.5-mm plug
to the jack beneath the rubber flap on the side of the radio. Plugging
in earphones disconnects the internal speaker. Stereo earphones can
be used, however the output will be mono.
Maintenance
Do not expose your radio to extremes of temperature. The product
should be kept in a warm environment free from dust and damp. For
external cleaning use only a soft, clean, damp cloth. Use of deter-
gents may damage the finish.
Guarantee
Morphy Richards products are manufactured to internationally accepted quality
standards. In addition to your statutory rights, Morphy Richards guarantee your
product to be free from manufacturing and component defects for a period of TWO
YEARS from date of purchase.
If your product proves to be defective within 28 days of purchase, your Morphy
Richards dealer from whom the product was purchased will be pleased to replace it
free of charge.
Should your product develop a defect within the guarantee period but after the
replacement period, please return the product to the following address, together with
the proof of purchase, brief details of the symptoms and your own name and
address.
After Sales Division
Morphy Richards Limited
South Yorkshire
Your post office will provide a certificate of posting. The product will be
repaired and returned to you promptly.
If you need any further advice, please call our Helpline on: 0870 060 2614
(Mon-Fri)
Morphy Richards Website: www.morphyrichards.co.uk
446/8001/71 Rev 3
Morphy Richards Ltd, Talbot Road, Mexborough, S64 8AJ
6
Talbot Road
Mexborough
S64 8AJ
8
Advertisement
