70460 Rev 2
10/8/04
Operation
Please remember that the steam cleaner
operates by emitting steam at an increased
temperature of 120˚C. Never use it on
objects or surfaces which cannot resist this
temperature, delicate materials, dralon,
plastic, natural fur etc. Where any doubt
exists check carefully on a part of the
material where minor marks will not matter.
Filling the water tank
1 To fill, release the tank latch B and slide
the tank backwards from the rear of the
cleaner. C.
2 Remove the anti-scale cartridge filter D
by lifting upwards.
3 Fill to the 'max' line with water E.
B
C
D
10:44 AM
Page 4
4
4 Replace the filter carefully, push fully
down then re-fit the tank into the back of
the machine closing the tank latch
securely to lock the tank into place F.
WARNING: Do not use any
detergent.
On/off switch
1 When the water tank has been filled,
insert the plug into the power socket.
2 Switch the cleaner on by pressing the
heater switch · to 'I' G. The switch will
illuminate and the boiler will take 60
seconds to heat up. The cleaner is ready
to use when the heater switch light goes
out.
Note: the heater switch light will go on
and off during use. This is to keep the
steam at the correct temperature.
E
F
G