Advertisement
CM47560MUK Rev2_Instruction Booklet 25/11/2010 09:14 Page 4
Before first use
Remove the protective
cardboard between the base
and jug.
Wash the inside of the milk
frother using warm soapy
water and a soft damp cloth.
DO NOT use a scouring pad
or abrasive material as this
will mark the stainless steel.
Rinse and dry.
DO NOT IMMERSE IN
WATER
Instructions for
use
1.
Place the milk frother onto a
dry, level surface.
2.
Remove the lid by twisting
anti clockwise and lifting
upwards.
3.
Ensure the Frothing
Attachment › is fixed on to
the Blending Rod ‹. Screw
it on by rotating it clockwise
to tighten A.
A
4.
Pour milk into the jug.
When using the frothing
attachment use a minimum
150ml of milk, and a
maximum of 300ml.
Do not exceed the max level
indicator.
5.
Put the lid back onto the jug
by twisting clockwise into
place. The milk frother will
not operate until the lid is
locked into the handle B.
B
For details of other Morphy Richards products, please see our website:
4
UK Helpline 0870 060 2614
6.
Select the required
programme – Heat and Froth
fl or Froth ‡.
To heat and froth
Press the Heat and Froth
button fl on the jug. The
button will light up red and
the programme will begin.
It takes approximately 3
minutes to heat and froth
your milk, heating your milk
to a temperature of 65ºC.
When heating and frothing is
complete, the milk frother will
automatically switch off.
To stop mid cycle, press the
Heat and Froth button once,
there will be an approximate
30 second wait time before
the programme can be
restarted.
Note: After heating and
frothing, let the milk frother
cool down for approximately
30 seconds and always clean
before reusing.
To froth
Press the Froth button on the
jug ‡. The button will light
up blue and the programme
will begin.
It takes approximately 2
minutes to froth your milk,
when frothing is complete,
the milk frother will
automatically switch off.
To stop mid cycle, press the
Froth button once.
Always clean before reusing.
Pouring the milk
•
To make the perfect frothy
drink it is recommended that
the froth is separated from
the milk.
•
Use a spoon / spatula to
retain the froth in the jug,
pouring the milk into your
drink, adding the froth to the
top of your drink afterwards.
Replacement Parts 0870 157 6645
Flavoured milk
drinks
For best results, it is
recommended to use Crusha
Milkshake Mix.
Remove the lid by twisting
anti clockwise and lifting
upwards.
Ensure the Circular Whisk ›
is removed from the Frothing
Attachment ‹ C.
C
Pour milk into the jug. 150ml
minimum capacity, 500ml
maximum capacity.
For one serving of Crusha,
pour 25ml of Crusha syrup
and 175ml milk into the jug.
For two servings, simply
double the measures.
Put the lid back onto the jug
by twisting clockwise into
place. The milk frother will
not operate until the lid is
locked.
Press the Froth button ‡.
It takes approximately 2
minutes for your drink to be
prepared; when complete the
milk frother will automatically
switch off.
Ireland Helpline 1800 409119
Advertisement
