Related Manuals for Bob's Furniture Power Bob Essential
Summary of Contents for Bob's Furniture Power Bob Essential
- Page 1 OWNER’S MANUAL Installation & Operation Power Bob Essential Serial No. Rev1 09/2022...
-
Page 2: Table Of Contents
Table Of Contents Safety & Warranty Warnings ……………………………………………… 01 Parts List……………………………………………………………………………… 02 Preparatory Work ……………………………………………………………… 03 Standard Power Founda�on Setup …………………………………… 04 Power Founda�on Set Up For Use On Pla�orm Or Storage Bed …………………………………………………………………………………………… 07 Hand Control Instruc�ons ………………………………………………… 10 Headboard Bracket Installa�on Guide (Op�onal) ………………... -
Page 3: Safety & Warranty Warnings
Safety & Warranty Warnings Customer Service Toll Free: 1-844-696-6886 —01—... -
Page 4: Parts List
Parts List All electronics and components that need to be installed are located in boxes under the foundation or attached to the frame. Before discarding the packing materials, ensure that all the parts are accounted for. PARTS LIST (1) Power Supply with (1) Mattress Retainer (1)Hand Control (6) Adjustable Legs... -
Page 5: Preparatory Work
Preparatory Work Open the box lid, move away * Make sure the adjustable legs are properly tightened, and the plastic caps have been placed at the the outer packing box. bottom of the legs. Incorrect installation might cause the part to fail or damage the floor. Take out all the accessories ACCESSORIES BOX: from the packaging and put... -
Page 6: Standard Power Founda�On Setup
Standard Power Foundat ion Setup Two people are required to setup the foundation. Install 4 legs, make sure the Remove the bed from the box with a flipping motion, legs are tight. let the bed stand on the 4 legs. O A R O A R H E A... - Page 7 Standard Power Foundat ion Setup Connect the hand control and secure it with the connector lock. Uncoil the AC power cord, connect the DC power cord to the power supply. O A R H E A Power Supply DC Power Cord Hand Control Connector Hand Control Lay the bed completely flat.
- Page 8 Standard Power Foundat ion Setup Connect the power supply to the AC power source. O A R AC Power Source H E A Power Cord DONE! Customer Service Toll Free: 1-844-696-6886 —06—...
- Page 9 Power Foundat ion Set Up For Use On Pla�orm Or Storage Bed Two people are required to setup the foundation. Take the bed out of the box, put it on the slat base, do not install any legs. Uncoil the DC power cord and hand control connector.
- Page 10 Power Foundat ion Set Up For Use On Pla�orm Or Storage Bed Two people are required to setup the foundation. Lay the bed completely flat. Turn over the bed. Install the middle stabilizer bracket as shown. (*Optional parts are required to perform this setup.
- Page 11 Power Foundat ion Set Up For Use On Pla�orm Or Storage Bed Lift the head of the bed by hand control. Install the two stabilizer brackets as shown. (*Optional parts are required to perform this setup. ) O A R H E A M8*16 Bolts Washers...
-
Page 12: Hand Control Instruc�Ons
Hand Control Instruct ions HAND CONTROL Lifts Head Lowers Head ADJUST This button lifts the head section of the foundation. This button lowers the head section of the foundation. Customer Service Toll Free: 1-844-696-6886 —10—... -
Page 13: Headboard Bracket Installa�On Guide (Op�Onal)
Headboard Bracket Installat Guide (Opt ional) A 1/2'' (13 mm) socket and 1/2'' (13 mm) wrench are necessary to complete installation. HEADBOARD BRACKET COMPONENTS (2) T-Brackets (8) Bolts M8*16 (4) Nuts (4) Washers (2) Headboard Brackets a)Align the slot hole of the headboard bracket to the holes of the a)To put the T-Bracket and Headboard Bracket together, you will side frame. -
Page 14: Troubleshooting
Troubleshoot ing In the event that the power foundation fails to operate, assess the symptoms and possible solutions provided in the chart below. SYMPTOMS SOLUTIONS Verify that the power cord is plugged into a working, grounded Hand control illuminates and appears to be operable, but will not electrical outlet.
Need help?
Do you have a question about the Power Bob Essential and is the answer not in the manual?
Questions and answers