Related Manuals for Hisense ULED X UXAU Series
Summary of Contents for Hisense ULED X UXAU Series
- Page 1 85UXNAU 110UXNAU Before using the TV, please read this guide thoroughly and retain it for future reference. English 1409979 ES-A243001-1...
-
Page 2: Table Of Contents
Figures and illustrations in this manual are provided for reference only and may differ from actual product appearance. Parts of the software function changes with the system upgrade. If you encountered difficulty when setting up your TV, we suggest you refer to the troubleshooting tips in the User Manual or the E-Manual. - Page 3 Declaration Any content and service accessed through this device, while only intended for individual non- commercial use, shall be the property of the applicable third party and subject to protection by regulations and laws on copyright, patent, trademark and other intellectual property rights. No part of such content and service may be modified, duplicated, published, uploaded, distributed, translated, marketed, or used to make and distribute products derived from it without the prior permission of the content owner or service provider.
- Page 4 Warning Safeguards Please read the following safeguards for Stability Hazard your TV and retain for future reference. A television set may fall, causing serious Always follow all warnings and instructions personal injury or death. Many injuries, marked on the television. particularly to children, can be avoided by taking simple precautions such as: 1.
- Page 5 circuits. Where installing an outside antenna 7. Ventilation system, extreme care should be taken to Slots and openings in the cabinet are keep from touching such power lines or provided for ventilation, to ensure reliable circuits as contact with them might be fatal. operation of the TV and to protect it from overheating.
- Page 6 an improper adjustment of other controls Do not mix and use new batteries with old batteries, or batteries with may result in damage and will often d i ff e r e n t t y p e s . D o n o t e x p o s e require extensive work by a qualified batteries to heat such as direct technician to restore the TV to its normal...
-
Page 7: Installation
Installation CAUTION Be sure to disconnect the AC power cord before installing a stand or wall mount brackets. The display on your TV is fragile. Make sure the TV screen is not scratched or damaged by hard objects or from pressure. After the installation is completed, make sure the TV is steady on a table or firmly attached to a wall mount, before removing all protective film, if any. - Page 8 Base Stand 110" CAUTION Four or more people are needed to lift and move the TV. The weight of TV with base stands is 239.2 lbs (108.5 kg). The furniture where the TV is placed should be tough enough to support. Make sure that the width of the furniture is above 19.2 inches (487 mm).
- Page 9 3. Attach the TV base stands to the slots where the Base Covers are removed. Use the screws provided to secure each base stand tightly. There are two options for the base mounting height. If you want the TV to be higher, select H2. If you want the TV to be lower, select H1. Note: If your table is long enough to place the TV, then insert the base stands into the screw holes ‘A’...
-
Page 10: Installing The Wall Mount Bracket
Installing the wall mount bracket Before mounting the TV, remove the TV stand if you have already attached it, and make sure the wall mount bracket supports the weight of your TV. CAUTION When mounting the TV on a wall, follow instructions provided with the wall mount bracket. If it is not correctly mounted, the TV may fall and cause property damage or personal injury. - Page 11 110" NOTE Please attach one end of the P-Clip to a concrete wall or brick structures wall. Wood or gypsum structures wall cannot be used directly and is in need of special reinforcement. 1. Drill a fixation hole on the wall. The aperture is 12mm and depth is 70mm. 2.
-
Page 12: Tv Front And Rear
TV Front and Rear Microphone AC INPUT Power indicator/ Built-in microphone Power button control button (Standby/Source) Voice Indicator Item Description Power indicator The light is white in standby mode. Press the button to turn the TV on. Press it again to bring Power button up the control menu and move the focus between different (Standby/Source) -
Page 13: Connection
Connection Terminals Connect an outdoor VHF/UHF antenna or cable. Connecting a satellite antenna. HDMI Connect an HDMI cable from an external equipment. Connect an HDMI cable from an external digital audio system. HDMI Please note that it works only when the TV is connected to the (eARC) audio receiver that supports the eARC function. - Page 14 Network Wired setup Connect your TV to your network by connecting the LAN port on the back of your TV to an external modem or router using a LAN (Ethernet/Cat 5) cable. See the illustration below. · We recommend you to use a modem or router that supports Dynamic Host Configuration Protocol (DHCP).
-
Page 15: Remote Control
Remote Control Buttons of remote control Power on/Standby Select input sources Quick access buttons to apps Custom button to launch input or apps quickly Fast access to app store Special function buttons Quick setup Playpad keys OK / Display the on-screen Navigation buttons keyboard (Up/Down/Left/Right) - Page 16 Power on/Standby Select input sources Quick access buttons to apps Custom button to launch input or apps quickly Quick setup Playpad keys OK / Display the on-screen Navigation buttons keyboard (Up/Down/Left/Right) Under the Menu or App, Exit the menu or exit return to the previous the application place...
- Page 17 Installing Batteries in the Remote Control(for battery-replaceable remote) 1. Slide the back cover to open the battery compartment of the remote control. 2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the batteries with the (+) and ( - ) ends indicated in the battery compartment.
-
Page 18: Remote Control Operation Range
Pairing the Remote Control (only for Bluetooth remote control) Pair the remote to the TV after you power it on. Keep the remote control within 3 metres from the TV. Press any button (except power and mic button) to pair. NOTE In special cases, press and hold [ ] button to pair. -
Page 19: Specifications
Specifications Features, appearance and specifications are subject to change without notice. Item 85" Without Stand 1936 × 1096 × 47 (W × H × D) Dimension (mm) With Stand 1936 × 1128 × 447 (W × H × D) Without Stand 53.5 Weight (kg) -
Page 20: Other Information
Other Information Disposal of Used Electrical & Electronic Equipment Packaging and electrical goods should be recycled appropriately, and not treated as household waste. Please dispose of this equipment at your applicable collection point for the recycling of electrical & electronic equipment waste. By ensuring the correct disposal of this product, you will help prevent potentially hazardous to the environment and to human health, which could otherwise be caused by unsuitable waste handling of this product.
Need help?
Do you have a question about the ULED X UXAU Series and is the answer not in the manual?
Questions and answers