Use personal protective equipment. Always wear eye son using only identical replacement parts. This will en- protection. Protective equipment such as dust mask, sure that the safety of the power tool is maintained. 1 609 92A 485 | (6.11.17) Bosch Power Tools...
Page 15
Anyone entering the work area must wear personal point of snagging. protective equipment. Fragments of workpiece or of a broken accessory may fly away and cause injury beyond immediate area of operation. Bosch Power Tools 1 609 92A 485 | (6.11.17)
Page 16
Investigate and take corrective action to elimi- rised customer service agent. The replacement plug should nate the cause of wheel binding. have the same fuse rating as the original plug. 1 609 92A 485 | (6.11.17) Bosch Power Tools...
11. Provide for sufficient dust extraction when cutting stone. The protection guard for cutting 11 is mounted in the same manner as the protection guard for grinding 6. Bosch Power Tools 1 609 92A 485 | (6.11.17)
Page 18
13. Screw in and tighten the four screws again. See graphics page for the mounting sequence. Screw on the round nut 16 and tighten with the two-pin span- ner. 1 609 92A 485 | (6.11.17) Bosch Power Tools...
Do not use damaged, out-of-centre or vibrating grin- ding tools. Damaged grinding tools can burst and cause in- juries. When cutting profiles and square bar, it is best to start at the smallest cross section. Bosch Power Tools 1 609 92A 485 | (6.11.17)
Tel.: (02) 8999091 If the replacement of the supply cord is necessary, this has to Fax: (02) 8976432 be done by Bosch or an authorized Bosch service agent in or- rosalie.dagdagan@ph.bosch.com der to avoid a safety hazard. 1 609 92A 485 | (6.11.17)
Page 21
Tel.: 02 6393111, 02 6393118 environmental-friendly recycling. Fax: 02 2384783 Do not dispose of power tools into household waste! Robert Bosch Ltd., P. O. Box 2054 Bangkok 10501, Thailand www.bosch.co.th Subject to change without notice. Bosch Service – Training Centre La Salle Tower Ground Floor Unit No.2...
Need help?
Do you have a question about the Professional GWS 660 and is the answer not in the manual?
Questions and answers