Frigidaire FAD704TDD2 Use & Care Manual page 3

Operating Instructions
Allow the unit to reach room temperature before operating.
To begin operating the dehumidifier, follow these steps:
Unit must be upright for one hour prior to operating.
1. Plug the power cord into a properly grounded 115 volt AC outlet. The POWER indicators will illuminate.
If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch.
H_GH _ _Uc_EuLu
ON LOW FILTER RESET POWER
_ _ HUMIDITYSETTING _ _ V
\
2. To turn the unit on press the ON/OFF button. The unit will run in the factory setting of CONTINUOUS and high fan speed.
In the Continuos Mode the unit will only display CO and not the room humidity. It is recommended you leave the unit
running in the CONTINUOUS setting for the first three or four days until the sweating and dampness odors have stopped.
_____
@2009 Electrolux Home Products, Inc. All rights reserved.