Table of Contents
Advertisement
Computer in the MID
After three incorrect code entries, or
three attempts to start the engine
without a code entry, the alarm will
sound for 30 seconds on vehicles
equipped with an alarm system.
Deactivating the alarm in an emer-
gency:
If you have forgotten the code, proceed
as follows:
1. Disconnect the battery, wait approx.
2 minutes, then reconnect it. Note
that on vehicles with an alarm
system, the alarm will sound
2. Turn the ignition key to position 1:
The time display will count down for
the next ten minutes
3. After ten minutes, start the engine.
If the code becomes available
again in the meantime, it can be
entered during the waiting period after
pressing the CODE
button.<
*
Remote control
The button on the turn signal indicator
lever can be used to select the com-
puter data which are to be displayed.
To do this, press
> the button on the lever until PROG 1
shows on the display
> the MID buttons in the order in which
you wish the information to be
displayed.
Each time an entry is stored, the
program number appears on the
display.
To terminate the selection procedure:
Press the right side of the button.
To have all the available information
displayed, press
> the button on the lever until the
display shows PROG 1
> the SET button.
To obtain individual items of informa-
tion, press the button briefly as often as
necessary.
Online Edition for Part No. 01 41 0 156 818 - © 07/02 BMW AG
97n
Advertisement
Table of Contents
