Advertisement
Advertisement
Table of Contents
Related Manuals for RadioLink CM120
Summary of Contents for RadioLink CM120
- Page 1 CM120 Battery Charger (For 1S LiPo battery) User Manual...
-
Page 2: Table Of Contents
Contents 1. Safety Precautions ..............................2 2. CM120 General Introduction ..........................2 3. Specifications ................................2 4. Instructions for Use ..............................3 5. Troubleshooting for Common Problems ......................4... -
Page 3: Safety Precautions
1. Please read this manual carefully before using to make sure CM120 is safely operated. 2. Please connect CM120 to the power supply first, and then connect the 1S LiPo battery for charging. 3. Keep the charger always away from children and pets. -
Page 4: Instructions For Use
Note: Please make sure the input voltage of the charger is 5V. It is prohibited to use a power supply exceeding 5V as the power source for CM120 charger to charge the battery, as it may burn out the charger or... -
Page 5: Troubleshooting For Common Problems
2. Please flip the black switch on the bottom of the charger CM120 (as shown below) to select 1A or 2A charging current. The red LED flashes slowly to indicate the charging status. The green LED stays on indicates the fully charged status. And the red and green LED flash alternately to indicate a fault. - Page 6 Facebook Messenger If the above information cannot solve your problem, you can also send emails to our technical support: after_service@radioLink.com.cn This content is subject to change. Download the latest manual of CM120 from https://www.radiolink.com/cm120_manual Thank you again for choosing RadioLink product.
Need help?
Do you have a question about the CM120 and is the answer not in the manual?
Questions and answers