Download Print this page

RadioLink CB86-PLUS How-To

Balance charger discharger 8 charging ports 1s-6s 162w 6a for lipo fast charging

Hide thumbs Also See for CB86-PLUS:

Download this manual

How to measure power supply voltage and battery voltage

with CB86-PLUS charger when you have no multi-meter?

The voltage of CB86-PLUS charger needs to be re-calibrated after

upgrading the firmware from Version 2.4 to Version 2.5 and above. If you

don't have a multi-meter, you can measure the power supply voltage and

battery voltage with CB86-PLUS charger under the condition that the

current voltage display of CB86-PLUS is correct. The steps are as

follows:

1. Before upgrading the firmware, plug the battery into the rightmost

interface of port 1. Wait for 30 seconds and then check the voltage of

each cell in port 1. Record the voltage value on the second row of the first

box, as shown in the picture below. The battery voltage can be recorded

as 4.200V in the picture (make sure that the cell voltage is between

3.8-4.4V). The power supply voltage can be recorded as 12.003V, shown

in the upper left corner of the charger screen.

Need help?

Do you have a question about the CB86-PLUS and is the answer not in the manual?

Page 1 CB86-PLUS charger under the condition that the current voltage display of CB86-PLUS is correct. The steps are as follows: 1. Before upgrading the firmware, plug the battery into the rightmost interface of port 1.
Page 2 2. Install the new firmware immediately, and then re-calibrate the voltage of CB86-PLUS charger according to the following tutorial. The power supply voltage during calibration is set to 12.003V and the battery voltage to 4.200V, which are the voltage value just recorded.