Safety and Regulatory Information
Review this product and related documentation to familiarize yourself with safety markings
and instructions before you operate this instrument.
This product has been designed and tested in accordance with the standards listed on the
Manufacturer's Declaration of Conformity, and has been supplied in a safe condition. The
documentation contains information and warnings that must be followed by the user to ensure
safe operation and to maintain the product in a safe condition.
Caution
Warning
www.valuetronics.com
The CAUTION notice denotes a hazard. It calls attention to a procedure
which, if not correctly performed or adhered to, could result in damage to or
destruction of the instrument. Do not proceed beyond a
indicated conditions are fully understood and met.
The W ARNING notice denotes a hazard. It calls attention to a procedure which,
if not correctly performed or adhered to, could result in injury or loss of life. Do
not proceed beyond a W ARNING sign until the indicated conditions are fully
understood and met.
When you see this symbol on your instrument, you should refer to the
instrument's instruction manual for important information.
The CSA mark is the Canadian Standards Association safety mark.
The CE mark is a registered trademark of the European Community. If it is
accompanied by a year, it indicates the year the design was proven.
This symbol indicates that the instrument requires alternating current (ac) input.
This symbol is used to mark the STANDBY/OFF position of the power line
switch.
This symbol is used to mark the ON position of the power line switch.
This text indicates that the instrument is an industrial Scientic and Medical
Group 1 Class A product (CISPER 11, Clause 4).
The C-tick mark is a registered trademark of the Spectrum Management Agency
of Australia. This signies compliance with the Australian EMC Framework
regulations under the terms of Radio communications Act of 1992.
caution
sign until the
iii
Need help?
Do you have a question about the 8510C and is the answer not in the manual?
Questions and answers