Bosch SMV2ITX09E Information For Use page 26

en Rinse aid system
Add rinse aid up to the max mark.
2.
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
11.2 Setting the amount of
rinse aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
Press ⁠ .
1.
To open the appliance settings,
2.
press
flashes.
a
Press
3.
flashes.
26
max
for 3 seconds.
repeatedly until
Press repeatedly until the
4.
right amount of rinse aid has been
set.
A
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
The factory setting is level 2
(LED A and LED B → Page 15).
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
– A higher setting adds more
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
To save the settings, press
5.
for 3 seconds.
11.3 Switching the rinse aid
system off
If you find the rinse aid refill indicator
irritating, e.g. when using combined
detergents with a rinse aid compon-
ent, you can switch the rinse aid sys-
tem off.
Tip: The function of rinse aid is lim-
ited with combined detergents. You
will generally get better results using
rinse aid.
Press ⁠ .
1.
To open the appliance settings,
2.
press
flashes.
a
Press
3.
flashes.
Press repeatedly until no LED
4.
→ Page 15 lights up (level 0).
B C
for 3 seconds.
repeatedly until