Lezyne HECTO STVZO 230+ Manual

74321-B1
MANUAL - EN -
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws mandating
lighting vary from country to country. Inform yourself about lighting laws and regulations in the country of use.
HECTO STVZO 230+
Warnings
DO NOT LOOK DIRECTLY INTO LIGHT BEAM or shine into eyes of another.
Lezyne LED Lights have a water resistance rating of IPX7 under IEC standard 60529. Submerging the device is not recommended. If
moisture does enter the casing, air out until completely dry.
DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty.
Lezyne USA Inc. does not accept any liability for injuries or other damages resulting from the use of this product in any circumstances.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the original purchase date to the original owner (proof of
purchase required). Lezyne Batteries carry a six (6) month warranty from the original purchase date. Lezyne warranties cover any
manufacturing defects in materials or workmanship. Issues not covered by warranty include normal wear & tear, improper
installation, attempting to access or modify electronics, damage or failure due to accident, misuse, abuse and/or neglect.
For all warranty issues worldwide, please contact the retailer that sold the product.
For any warranty questions contact: warranty@lezyne.com
Mounting
The light must be mounted in a height between 400 mm and 1200 mm. It must be ensured that the light technical equipment
will not be covered by any parts of the bike (tire, etc...).
Between
400 mm
and
1200 mm
HECTO STVZO 230+
MICRO STVZO 300+
HECTO PRO STVZO 400+
Operation
1. On/Off: hold button two (2) seconds.
2. Mode cycle: click button
HECTO STVZO 230+
MODE MEMORY: The light remains in the output setting it is switched OFF in.
THERMAL PROTECTION: If the operating temperature of the light is too high, the light automatically lowers the lumen output.
Run Times and Modes
HECTO STVZO 230 +
ECONOMY BLAST
40 230
LUMENS LUMENS
6:15 4:00
h : min h : min
Power Pack +
Compatible
MICRO STVZO 300 +
FEMTO ECONOMY
40 220
LUMENS LUMENS
6:15 4:30
h : min h : min
Power Pack +
Compatible
HECTO PRO STVZO 400 +
FEMTO ECONOMY
40 250
LUMENS LUMENS
9:15 4:00
h : min h : min
Power Pack +
Compatible
Battery Indicator
An LED, located in the button, displays current battery status while light is ON. When light is OFF, click button once to
momentarily display battery status.
100%
Illuminates green
Charging
Before using your Lezyne LED Light for the first time, fully charge the battery.
To charge your light:
1. Switch light OFF
2. Remove USB-C protective cover
3. Connect USB-C cable and light to powered USB-C port
4. Once charging, button will flash green
If button does not flash when plugged in, selected USB-C port may not be powered—try another USB-C port.
Light will be charged after 4–7 hours or when button illuminates solid green or blue.
5. Remove light from charger and reinstall USB-C protective cover—ensure USB-C protective cover is fully installed for water
resistance.
Charging
Flashes green
More Information
For more information on Lezyne products, visit:
CORPORATE HQ
Lezyne USA, Inc.
5470 Kietzke Lane, Suite 300
Reno, NV 89511
HECTO STVZO 230+
MICRO STVZO 300+
HECTO PRO STVZO 400+
BLAST
300
LUMENS
2:45
h : min
BLAST
400
LUMENS
2:45
h : min
50%
Illuminates yellow
or red/green
Fully Charged
Illuminates green
www.lezyne.com
CALIFORNIA OFFICE
Lezyne USA, Inc.
645 Tank Farm Rd., Suite F,
San Luis Obispo, California
93401
74321-EMANUAL FOR Y17 HECTO STVZO 230+ MICRO DRIVE STVZO 300+HECTO PRO STVZO 400+ -EN-R0B1
MICRO STVZO 300+
MICRO STVZO 300+
10%
Illuminates red
USB-C Cable Not Included
TAIWAN BRANCH / MANUFACTURER
Lezyne USA, Inc. - Taiwan Branch
No.162, Shigu Lane
Guozhong Road, Dali District
Taichung City 412, Taiwan, ROC
HECTO PRO STVZO 400+
HECTO PRO STVZO 400+
EU SINGLE POINT OF CONTACT
Lezyne Europe GmbH
Rolandstrasse 4
14129 Berlin, Germany
For all inquiries, contact: support@lezyne.com
Floor