1. Introduction The PoE injector is the ideal solution for expanding your network in locations without a power connection. Fully compatible with the IEEE 802.3af/at standards, it is perfect for power supply and data transmission for PoE-capable devices such as access points (AP), IP cameras, IP telephones or PoE receivers.
4. Specifications OUT: 1x 10/100/1000Mbps RJ45, Connections IN: 1x 10/100/1000Mbps RJ45 PSE Power on Mode A: 1/2(+),3/6(-) RJ-45 PoE standard IEEE802.3af/at 10BASE-T: UTP category 3, 5 (up to 100m), Network cable 100BASE-TX: UTP category 5, 5e (up to 100m), 1000BASE-T: UTP category 5e, 6 (up to 100m) PoE power Up to 30W Input voltage...
Data IN: This port is an RJ-45 Ethernet connector where data is received and transmitted through the PoE Injector. AC Power Input Connector: This connector connects the AC power source to the PoE Injector. LED indicator Color Function Off: No PoE supply. Green Light: Indicates the machine has PoE supply...
Page 5
Ensure proper ventilation of the equipment room and keep the ventilation vents of the machine free of obstruction. Make sure that the operating voltage is the same one labeled on the machine. Do not open the chassis while the switch is operating or when ...
Page 7
Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address. info@assmann.com Assmann Electronic GmbH Auf dem Schüffel 3 58513 Lüdenscheid Germany...
Need help?
Do you have a question about the DN-95103-3 and is the answer not in the manual?
Questions and answers