Dell DIMENSION 5100 User Manual page 70

7 Before you close the card retention door, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
8 Close the card retention door by snapping it into place to secure the card(s).
NOTICE:
the computer cover from closing properly or cause damage to the equipment.
9 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
NOTICE:
the computer.
10 Replace the computer cover, reconnect the computer and devices to electrical outlets, and
then turn them on.
11 If you installed a sound card:
Enter system setup (see page 105), select Audio Controller, and then change the setting
a
to Off.
70
Removing and Installing Parts
release tab
card retention door
Do not route card cables over or behind the cards. Cables routed over the cards can prevent
To connect a network cable, first plug the cable into the network device and then plug it into
alignment guide
alignment bar