Pioneer CT-8R Operating Instructions Manual page 2

IMPORTANT
To prevent electric shock, do not remove cover. No user serviceable parts inside, refer servicing to
qualified service personnel.
Always disconnect all the equipment from the mains supply when disconnecting the signal leads. The
power cord should be connected last, make sure that the power switch is off.
Unplug the set from the wal! socket when it is not to be used for an extended period of time.
LINE VOLTAGE SETTING
You will find the line voltage selector switch on rear panel. This switch has positions for 220V and
240V power sources.
Before your tape deck is shipped from the factory, the switch is set to the power requirements of the
destination; nevertheless, you should check that it is set properly before plugging the power cord into
the AC OUTLET. If the voltage is not properly set or if you move to an area where the voltage re-
quirements differ, adjust the selector switch as follows. Before adjusting, disconnect the power cord.
1. Loosen the screw on the VOLTAGE SELECTOR plug with a Phillips screwdriver, then take out
the plug.
2. Re-install the plug with its cutaway section exposing the correct voltage indication as illustrated
below.
. Tighten the mounting screw.
Selector plug
screwdriver
QR)
6) Socket
oO
Mounting screw
DEW CONDENSATION
When the unit is moved from a cold to a warm room, or a quick temperature change occurs, condensation will form
on the mechanical parts affecting performance of the unit. In such cases, leave the unit in the warmer atmosphere for
approximately one hour, or gradually change the room temperature.
NOTE:
When locating the tape deck, do not place a cloth over the top or block the ventilation openings in any other way.
The word ''Dolby"' and QQ are trademark of Dolby Laboratories Licensing Corporation.
Noise Reduction System manufactured under license from Dolby Laboratories Licensing
Corporation.