Pioneer CT-A9 Operating Instructions Manual

STEREO CASSETTE TAPE DECK
GT-A9
Thank you for buying this Pioneer product.
Please read these operating instructions thoroughly, so you will know
how to operate your model properly. After you have finished reading
the instructions, put them away in, a safe place for future reference.
For the sake of convenience, these operating instructions are based
on the model HEM, and they can be used for the HB, HP, KU, KC, D
and D/G models.
The differences between the models are given below.
HEM model:
For Europe excluding U.K. ('HEM' stamped on packing case): Power
line voltage is AC 220 volts.
HB model:
For U.K. ('HB' stamped on packing case): Power line voltage is AC
240 volts.
HP mo d el:
For A.rstralia ('HP' stamped on packing case): Power line voltage is
AC 221.0 volts.
KU and KC models:
For U.S.A. and Canada ('KU' or 'KC' stamped on packing case):
Power line voltage is AC 120 volts.
D and D/G models:
For destinations excluding above ('D' or 'DlG' stamped on packing
case): A 3-point (120 V /220 V /240 V) voltage selector switch is pro-
vided.
NOTE:
Depending upon the model, the design of the power plug and the
power outlet differs.
The line vottage selector switch is located on the rear panel of the
unit. Please check that it is set properly before plugging the power
cod into an outlet. lf it is not set properly, change the setting of it
according to the LINE VoLTAGE SELECTION on page 4.
IMPORTANT NOTICE (For KU and KG models)
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card and
keep in a secure place. This is for your security.
WARNIN G: T O PRE VENT F IR E O R
SHOCK HAZARD, DO NOT EXPOSE
T HIS AP PLIA NCE TO RAI N O R
M OIST URE.
(D rrloNEEFl'