Froggy's Fog FRG-400 User Manual

FROGGY'S FOG - FOG MACHINE USER MANUAL
Thank you for choosing Froggy's Fog Fog Machines. Prior to use, we suggest that you carefully read
all of the instructions. By following the suggestions found in this user manual, you can look forward
to the reliable and satisfactory performance of your fog machine for years to come. Please follow
these operation, safety and maintenance instructions to ensure a long and safe life for your fog
machine.
•
Open the box to make sure that there is no evident damage caused by transportation and verify machine has arrived intact. In the event that the unit's
housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your dealer for assistance.
•
Remove all packing materials from the box and fog machine, especially in the nozzle area.
• Place the fog machine on a level flat surface. Remove the fog liquid tank cap and fill it with Froggys Fog brand fog fluid. Lower quality fluid can damage the
unit. Replace the cap back on the liquid tank.
•
For Ground Fogger, additionally, fill the front basket with ice allowing room to securely close and seal the lid.
• Firmly attach the Wired Remote Control cable to the proper input on the rear of the machine.
•
Plug the power cord into a grounded electrical outlet. If necessary, turn power switch on rear of unit to "1" position. Warm-up is complete when the LED on
trigger unit illuminates.
•
To emit fog, press the remote trigger button for the desired length of time.
•
The trigger's LED will cycle on and off as the machine re-heats to the proper operating temperature before producing fog.
•
If your model includes a mounting bracket designed for overhead installation, it may be installed at floor level or suspended overhead. If the unit is to be
mounted using the bracket, it is important that the fog does not shoot directly at another person. Whatever installation method you choose, do not allow
the unit to have more than a 15-degree angle of inclination.
•
Do not use for more than 8 hours continuously.
Important: Always monitor the tank fluid level. Running a fog machine with no fluid can permanently damage the pump unit.
chassis free from blockage. Do not allow the fog liquid to become contaminated, always replace the cap on the fog liquid container and liquid tank right after
filling.
If low output, pump noise or no output at all, unplug immediately. Check fluid level, external fuse, remote connection, and power connection.
If fog is not being produced, check the fluid hose to make sure there is fluid going through it. If you are unable to determine the cause of the problem, do not
simply continue pushing the remote button, as this may damage the unit.
Cleaning your fog machine regularly will help reduce costly parts replacement and repair.
Please follow these instructions for safely cleaning your Fog machine if output become noticeably decreased. Typical service intervals are every 40 hrs. of
machine use. High quality fluid recommended by the manufacturer lengthens the amount of time between periods of maintenance as described below.
Best operated at 40-90 degrees F. In colder climates, performance will be reduced.
1
MODEL FRG-400
VOLTAGE: 110V/60HZ
POWER: 400W
FUSE: 125V/5A
WARM UP TIME: 5 Min
DISTANCE (M): 3-5
OUTPUT (CFM): 3000
TANK
CAPACITY (L): 0.25
SIZE L x W x H
(IN): 9" x 4.3" x 5.1"
WEIGHT: 2.9 lbs., 1.3 KG
Keep the air intake ports on the
FRG-1000
110V/60HZ
1000W
125V/10A
8 Min
6-10
7000
2.5
16.25" x 7.9" x 7.9"
9.3 lbs., 4.2 KG