To facilitate air outlet, the ventilation duct should have a curvature of ≥120° and should be connected to the outside wall. BOLERO FLUX PM 606500 INOX A / BOLERO FLUX PM 606500 BLACK A...
Figure 9 shows how to release the filter from the kitchen hood. Follow the instructions below: BOLERO FLUX PM 606500 INOX A / BOLERO FLUX PM 606500 BLACK A...
Page 4
Fig. 10 Replacing the light bulb/lamp Please note: The light bulb must be replaced by the official Cecotec Technical Support Service or similarly qualified technicians. Always disconnect the power supply before performing any operation on the appliance. When handling the bulb, make sure that it has cooled down completely before any direct contact with your hands.
There is too much ventilation in extracting Relocate and reinstall the the room due to open doors or kitchen hood. windows. BOLERO FLUX PM 606500 INOX A / BOLERO FLUX PM 606500 BLACK A...
The switch/controller of the appliance was set to the Off position. Symbol Value Unit 02870 Model identification 02871 Annual energy consumption 36.0 kWh/a hood Time increment factor Fluid dynamic efficiency 30.3 hood BOLERO FLUX PM 606500 INOX A / BOLERO FLUX PM 606500 BLACK A...
Compliance with the above guidelines will help protecting the environment. 9. TECHNICAL SUPPORT AND WARRANTY Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the time of delivery of the product under the terms, conditions, and deadlines established by the applicable regulations.
Page 8
ENGLISH If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact the official Cecotec Technical Support Service at +34 96 321 07 28. 10. COPYRIGHT The intellectual property rights over the texts in this manual belong to CECOTEC INNOVACIONES, S.L.
Need help?
Do you have a question about the BOLERO FLUX PM 606500 INOX A and is the answer not in the manual?
Questions and answers