De Raat Primor 2600 Manual

Primor 2600
Opening the safe for the first time
Enter the factory code. The
factory code is always 123456.
Now turn the keypad to the
right. The vault door should
now unlock and open within
3 seconds.
Changing the master code
Caution! Change the master code only with an open safe
door!
Press and hold "0" until a
repeated double signal follows.
Enter the old code. You will hear
a double tone.
new
Enter the code. You will hear
a double tone.
After this, enter the new code
again. You now hear another
double tone. In the event of an
input error, you will hear a long
tone and the old code will remain
active.
Note: test the new code before closing the door. Should the new
code not work, try entering the old code first. Then repeat the
procedure "Changing the user code" until the new code is pro-
grammed.
The lock works with a 6-digit code. One user code and one ma-
ster code can be programmed. Every code entry is confirmed by
a signal consisting of a beep and the light up. A valid code is
followed by a double signal. If the code is invalid, a long signal
follows. If there is a pause of more than 10 seconds, the code
previously entered disappears and the entire code has to be
entered again.
Signal
LED flashes every 10 seconds
How to add an user code
Press and hold "1" until the LED light
turns red.
Enter the master code.
Then enter your new user code. If
you hear 2 beeps, the code has been
successfully entered. If you hear a
long tone something is wrong, start
again.
How to delete an user code
"3" until repeated double signal fol-
lows. LED remains on during proce-
dure.
Enter the master code.
The user code has now been deleted.
Closing the safe
Close the door of the safe and turn
the lock completely to the closed
position. The lock is closed. You can
test the lock for verification.
Explantion icons
Explanation signal Comment
Code is correct
Code is wrong
Short acoustic signal
Long acoustic signal
Blockage is active
Battery is almost empty Battery has to be replaced quickly