Adjusting The Reverb Effect Volume Of Each Program; Adjusting The Delay Effect Volume Of Each Program; Adjusting The Chorus Effect On/Off On Each Program - Akai Ewi4000s Reference Manual

Adjusting the Reverb Effect Volume of Each Program

This procedure adjusts the volume of the Reverb effect for each Program individually, as opposed to the
overall Reverb effect volume. The Reverb effect volume of each program is stored in the EWI4000s.
1. Select the program whose Reverb effect volume you want to adjust.
2. While holding the FX BUTTON, press the SETUP BUTTON. While pressing
both these buttons, "rb" will be shown in the PROGRAM / DATA DISPLAY.
3. Release both buttons.
program will be displayed.
4. Adjust the Reverb effect volume by pressing the HOLD BUTTON (which increases the volume value) or
OCTAVE BUTTON (which decreases the volume value).
5. Press the SETUP BUTTON. The EWI4000s will return to Play Mode.

Adjusting the Delay Effect Volume of Each Program

This procedure adjusts the Delay effect volume for each Program. The Delay effect volume setting of each
program is stored in the EWI4000s.
1. Select the program you wish to adjust the Delay effect volume.
2. While holding the FX BUTTON, press the SETUP BUTTON. While pressing both these buttons, "rb"
will be shown in the PROGRAM / DATA DISPLAY.
3. While pressing the SETUP BUTTON, release the FX BUTTON, then press the
HOLD BUTTON so the PROGRAM / DATA DISPLAY now shows "dL."
4. Release the SETUP BUTTON and HOLD BUTTON. The current Delay volume
of the selected Program will be displayed.
5. Adjust the Delay volume by pressing the HOLD BUTTON (which increases the volume value) or
OCTAVE BUTTON (which decreases the volume value).
6. Press the SETUP BUTTON. The EWI4000s will return to Play Mode.

Adjusting the Chorus Effect On/Off on Each Program

This procedure selects whether the Chorus effect is set on or off for each Program. The Chorus effect
setting of each Program is stored in the EWI4000s.
1. While holding the FX BUTTON, press the SETUP BUTTON. While pressing both these buttons, "rb"
will be shown in the PROGRAM / DATA DISPLAY.
2. While pressing the SETUP BUTTON, release the FX BUTTON, then press the
HOLD BUTTON so the PROGRAM / DATA DISPLAY now shows "CH."
3. Release the SETUP BUTTON and HOLD BUTTON. The current Chorus setting
of the selected program will be displayed.
4. Set the Chorus to either "on" or "OF" by pressing the HOLD BUTTON or OCTAVE BUTTON.
5. Press the SETUP BUTTON. The EWI4000s will return to Play Mode.
The current Reverb effect volume of the selected
22