Advertisement
Quick Links
USING THE SIDE BURNER
LIGHTING INSTRUCTIONS
First remove the burner cover and any cooking utensils from the burner grate. Push and turn the control knob
to the "HI" position until the burner is lit or 4 seconds pass. If the burner doesn't ignite, wait 5 minutes for any
accumulated gas to dissipate then try again. If the burner will not light after several attempts, check the trouble-
shooting instructions on page 18.
MATCH LIGHTING
Hold a lit fireplace match near the burner ports, turn the control knob counterclockwise to "HI". Rotate the knob
immediately once the burner is lit to the desired setting.
Note:
If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been
turned "off". This "extinction pop" is normal for propane gas.
16
Control
Knob
FIG. 11 BGC132 Shown
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for DCS BGC132-L
Summary of Contents for DCS BGC132-L
- Page 1 USING THE SIDE BURNER LIGHTING INSTRUCTIONS First remove the burner cover and any cooking utensils from the burner grate. Push and turn the control knob to the “HI” position until the burner is lit or 4 seconds pass. If the burner doesn’t ignite, wait 5 minutes for any accumulated gas to dissipate then try again.
- Page 2 CARE AND MAINTENANCE The side burner will give you years of trouble free service if properly maintained. The body panels and front valve panel and burner hanger are made from non-rusting high grade stainless steel. The burner is heavy duty cast iron and brass.
- Page 3 TROUBLESHOOTING PROBLEM WHAT TO DO Burner won’t light when the Remove the burner grate. With the control knob in the ignition is pushed. “OFF” position, push the control knob in and listen to the electrode. There should be a spark from the electrode. When the spark jumps, it makes a ticking sound.
Need help?
Do you have a question about the BGC132-L and is the answer not in the manual?
Questions and answers