Breg DVT Guardian Quick Installation Manual

1.
1. Charge Device – Plug power charger into port and wall power
supply. Charge until all four battery indicator lights are solid
green, and no longer flashing.
2. Apply Leg Wrap Cuffs – Wrap one cuff around each calf, and
fasten straps securely. Wrap can be applied to either leg.
3. Turning On & Off – Hold button until you hear single beep to turn
on. Hold button until you hear two beeps to turn off.
For additional information, refer to instructions for use booklet
For more information, please contact Breg Customer Care at
Toll Free Tel: 1-800-321-0607
Local: +1-760-795-5440
2. 3.
4. Unit Display:
a Battery Level Indicator – The display shows 4 green lights
when it is fully charged.
b Time – Shows the cumulative number of hours the device has
been in use.
c Air Pressure Value – Shows the amount of pressure being
applied by the compression of the device.
www.breg.com/dvtguardian
Quick Start Guide
4.
a.
b.
©2024 Breg, Inc. All rights reserved.
DVT Guardian is a trademark of Breg, Inc
11.000027 Rev A 0824
c.