Table of Contents
Advertisement
Symptom
Picture drops
Momentary freeze
out
frame
Continuous freeze
frame
Picture pixeling
" Searching for
satellite" displayed
on monitor
" Repositioning"
displayed on monitor
" INIT-REV XXXX"
displayed
" Cal. Required"
displayed on monitor
5.1
Failure Messages
Failure messages are described in Table 2. If any of these messages are displayed contact your nearest
Authorized Service Center or call Datron directly at (800) 287-5052.
Failure Messages Displayed
on Screen
CODE: 01 AZ & EL
CODE: 02 AZIDX
CODE: 03 ELIDX
CODE: 04 A2D
CODE: 05 XRATE
CODE: 06 YRATE
CODE: 07 ZRATE
CODE: 08 PLEVL
Table 1. Error Conditions and Solutions
Indication
View obstructed
Large vehicular motion
Receiver malfunction
View obstructed
Large vehicular motion
Long time view
obstruction
Very large vehicular
motion
Vehicle turned past
limits
Re-acquisition not
successful
Displays when reset if
performed
Table 2. Failure Messages
Reason for Message Display
Both AZ and EL index
switches/motors failed.
AZ index switch/motor failed.
EL index switch/motor failed.
Fault in the analog-to-digital
converter.
X gyro rate sensor failed.
Y gyro rate sensor failed.
Z gyro rate sensor failed.
Pitch level sensor failed.
Cause
Normal operation
Turn receiver off and on
Normal operation
Normal operation; picture
should return within three
minutes
Reboot system
Normal operation; picture
should return within 30
seconds
Normal operation; picture
should return within three (3)
minutes
Calibration performed by
turning power off and on
every 10 seconds, five times
Contact nearest Authorized
Service Center or call Datron
at (800) 287-5052
M-01334, Rev. B
Page 29
Possible Solution
Possible Solution
Advertisement
Table of Contents
