Table of Contents
Advertisement
4.5
Installing the Antenna Power Switch
Determine the desired switch location and hold the switch bezel in that location to be sure
Step 1
that the switch assembly will fit. Also verify access and clearance behind the panel.
Using the switch bezel as a template, mark the locations of the 2 screw holes and the
Step 2
center rectangular opening. Drill the two mounting holes where marked using a 3/32-inch
drill bit.
Step 3
Using a hole saw; cut a 1-inch hole in the center of the rectangular pattern that was
marked in step 2.
Step 4
Feed the red and blue 22 gage wires from the inside of the vehicle panel, through the 1-
inch hole, so that 8 inches of wire extends through to the outside of the panel. Crimp a
faston connector onto the extended blue and red wire wires.
Step 5
Snap the switch into the bezel from the front side as shown in "front view" of Figure
4-12. Note that the vertical white line on the rocker switch should be located towards the
top of the switch plate. Then push the faston connectors onto the switch terminals as
shown in diagram "side view."
Step 6
Install the switch assembly into the panel and fasten using the 2 screws supplied.
Figure 4-12
M-01334, Rev. B
Page 25
Advertisement
Table of Contents
