Answering System Operation - Audiovox AXT847 Manual

has been set.
Ring Select
You can select the number of rings in which a call will be answered.
1. Press and hold the PLAY button unit
2. Press "SKlP" to set
"rt"
3. System be set and go to normal after a double "beep"
Toll Saver Facility
Your unit has a Toll Saver Facility. If you set to "rt" while Ring setting, this
means your unit will answer a call on the 5
nd
on the 3 rings if there is a new messages . Therefore when you are calling your
unit remotely you will know by the 3

??ANSWERING SYSTEM OPERATION

To turn unit ON or OFF
1. To turn the unit ON, press and release the ON / OFF button. The unit will
beep and the button will light up, your answering system will answer the call
after 3 or 5 rings.
2. To turn the unit OFF, press and release the ON / OFF button, the Display
(15) goes out, your answering system will answer the call after
note»> If there were outstanding messages when the unit was turned off, the
LED Indicator (17) flashes when the unit is turned on again and will Display the
total messages
Automatic Answering and Recording of Incoming Messages (ICMs)
1. Be sure that the answering system is turned ON. The display should read '00'
in ANSWER-RECORD mode.
2. When a call is received, your answering system will answer the call after
5 rings,
3. A beep tone will then sound to signal your caller to begin speaking.
4. After the tone, the system will begin recording and stop after the caller
finishes the message. If the message length exceeds one minute, the
answering system will sound a long beep and then release the line.
5. After the call, the display will indicate the total number of messages received.
And the LED indicator flashes.
6. If at any time you want to cancel automatic answering, press and release the
ON / OFF button, that the answering system is turned OFF, the unit will
beep and the Display and button goes out. Your answering system will
answer the call after
To avoid unnecessary pauses due to hang-up and to save message capacity, your
unit will automatically stop recording after 7 seconds of silence
Playing Back Incoming Messages (ICM)
Press and release the PLAY / PAUSE button to play back your new messages,
or to play back all of your messages if you have not new messages. The
Display will indicate the number of each message as it is played. At the end of
each message, the time and day of the recording will be announced if the
Set the 3 Rings "r3" or 5 rings " r5".or Toll saver
th
r d
ring if there are no new messages.
10 rings.
8
hear a long "beep".
ring if there are no new messages, or
10 rings.
3 or