Answering System Setup - Audiovox AXT847 Manual

settings.
Connecting the Power Ada ptor
Only use an adapter with "Class 2 "power source 9V 200mA Insert the plug of
the power adapter into the Jack at the back of the answering unit and connect the
adaptor to the mains power supply.
1. ANSWER ON-OFF / STOP Button will turn to ON and lighted, if not,
please press the Button to turn ON and lighed.
2. The unit will have a sound and the Display(15)will flash "00"and
"--" repeats this sequence until the clock and OGM has been set.
Note>> If the battery is installed incorrectly or exhausted, then "bL" is
added to the display.
If you do not want to be disturbed by incoming calls whilst you are setting up the
unit, it may be desirable at this stage to set the Clock Day / Time stamp and your
own Out Going Message (OGM) before following the connection procedure
Connecting to the Telephone Line
1. Plug one end of the TELEPHONE LINE CORD into the jack at the back of
the answering system marked TO TEL. LINE.
2. Plug the other end of the TELEPHONE LINE CORD into a modular
telephone wall jack. You may have to disconnect your existing telephone to
do this.
Connecting your Telephone
Plug the line cord from your existing telephone into the jack at the back of your
answering system marked TO TEL.
MACHINE RESET
CAUTION :IF you press machine RESET, unplug the unit from the telephone
line and power adaptor
If the system does not record messages or otherwise malfunctions, press the
machine RESET button on the bottom near the battery door of the base, pointed
instrument such as a pencil.
CAUTION : When you press machine RESET, the time / Security code setting
and any messages stored in memory are deleted even if a battery is installed.
?? ANSWERING SYSTEM SET UP
Bilingual English / French Setting
Slide the ENG / FRE switch on bottom of the units to select for day and time
stamp in English or French.
To record or change OGM for ANSWER-RECORD mode
It is important that you record your Outgoing Message (OGM) before
operating the answering system. Try to keep your announcement brief (under
30 seconds) as this maximizes the recording time available for incoming
messages.
1. Press and hold the OGM button, the Displays will show 'Ar' and you will
hear a long beep
2. Still hold the button and start recording your OGM announcement speaking
clearly towards the microphone (16) from approxim ately 6 - 8 inches. to
6