Remote Control Operation - Audiovox AXT847 Manual

?? The unit beeps, erases that message and then continues to replay the next
recorded message.
2. To erase all ICM messages
After all of the new ICM message has been played, you will hear a double
"beep", press and hold the DELETE button for (about 2 seconds) a long
"beep". All messages are now erased and the Display shows "00".
System Memory Full
The Displays "FL" when full. The unit can be recorded 17 minutes or 99
total number of ICM, Memo and Two-way messages.

?? REMOTE CONTROL OPERATION

Remote Access Code
Used to access your unit remotely. Before you can access your unit by remote
control, you must first enter a 3 digit Security Code into your unit. The unit
comes with a factory default Security Code of
any 3 digits ranging from 000 to 999.
?? To change or check the Security Code
1. Press and hold the
the code and
2. Release the button and the display scrolls the current code set after each
digit.
3. Press " SKIP" or "REPEAT" button to increment or decrement the digit.
4. If digit is correct, press and hold the
process for next digit.
5. If no key is pressed within 8 seconds, setup procedure will be aborted.
You can also press and hold the
Basic information about Remote Control Operation
1. Call your telephone number.
2. After end of OGM is played, you will hear a one "beep".
(If you forget to turn your unit ON, the unit will be answer after 10~15 rings)
3. Enter your 3 digit Security Code via the telephone keypad to go into
REMOTE CONTROL mode
4. Enter the key combination you desire from the list below
??
Enter " 1 and # " Playback only new message.
??
Enter " 2 and #" Playback all message.
??
Enter " 3 and # " Erase selected message during playback
??
Enter " 4 and # " Repeat previous message during playback
??
Enter " 5 and # " Stop message during playback
??
Enter " 6 and # " Skip a message during playback
??
Enter " 7 and # " Room Moni t or
??
Enter " 8 and # " Play Memo
??
Enter " 9 and # " Record Memo
After message playback, the unit emits two beeps and a long beep.
Within 7 seconds, you can press 2# to replay messages or press 3# to erase all
REPEAT button, after the "beep", the displays shown
announcing e.g. "2, 6, 8"
268 which can be changed to
REPEAT button to confirm. Repeat
REPEAT button to check security code .
10