Richter 3.63300 Assembly Instructions

ASSEMBLY INSTRUCTIONS
General information
A Surfacing requirements
This element is suitable for installation in a
number of ways and in combination with other
equipment. It should be installed on impact
absorbing surfacing or loose fill material that
accords with EN 1176 and is suitable for a
maximum free height of fall of up to ≤ 1.00 m
depending on the combination equipment or
installation situation.
At the run-out of the slide we recommend
sand as loose fill material.
B Foundations
Please take into account the special sheet:
„Notes on the construction of foundations."
Special information
Certified by TÜV Süd Product Service GmbH in
compliance with EN 1176.
Please do not alter any parts of the equipment
or the construction itself since this may affect
the safety standards and your guarantee. This
equipment is supplied with information on the basis
of it being used in combination with other Richter
equipment.
We reserve the right to make technical alterations!
For further information please call your local agent.
RICHTER SPIELGERÄTE GMBH · D-83112 FRASDORF · PHONE +49-8052/17980 · FAX 4180
ASSEMBLY INSTRUCTIONS
Stainless Steel Slides as combination element
or for installation on a slope
installed height 1.00 m
Order No. 3.63300
width 1.00 m
Order No. 3.63310/3.19220
width 0.45 m
Components
Number of parts: 2
1 slide
1 ground anchor and bolts
Weight:
For sequence of assembly operations
please refer to page 3.
ASSEMBLY INSTRUCTIONS
approx. 86 kg
Page 1