Datalogic Heron HD3130 User Manual
  1. Manuals
  2. Brands
  3. Datalogic Manuals
  4. Barcode Reader
  5. Heron HD3130
  6. User manual
Datalogic Heron HD3130 User Manual

Datalogic Heron HD3130 User Manual

Hide thumbs Also See for Heron HD3130:

Advertisement

Table of Contents

COBISS System Management
Datalogic Heron HD3130
User Guide
V1.0
VIF-NA-28-EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Heron HD3130 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Datalogic Heron HD3130

Summary of Contents for Datalogic Heron HD3130

  • Page 1 COBISS System Management Datalogic Heron HD3130 User Guide V1.0 VIF-NA-28-EN...
  • Page 2 © IZUM, 2015 COBISS, COMARC, COBIB, COLIB, IZUM are registered trademarks owned by IZUM.

  • Page 3: Table Of Contents

    1 Using the Datalogic Heron™ HD3130 Reader ........... 1 2 LED and Beeper Indications ................2 3 Setting Up the Datalogic Heron™ HD3130 Reader ........... 2 4 Settings for Interleaved 2 of 5 ................3 5 Additional Settings for LED Indicator ..............4 6 Additional Settings for Speaker Volume .............

  • Page 5: Using The Datalogic Heron™ Hd3130 Reader

    COBISS System Management Datalogic Heron HD3130User Guide Using the Datalogic Heron™ HD3130 Reader Power Cable Paper Clip Use a paperclip to help attach or remove the power cable. To use the HERON™ HD3130 reader in the COBISS system, connect it to your PC by using the USB port.

  • Page 6: Led And Beeper Indications

    Datalogic Heron HD3130User Guide COBISS System Management LED and Beeper Indications Setting Up the Datalogic Heron™ HD3130 Reader When connected, set up the reader by reading the bar codes on the right side of the manual from top to bottom. See the explanation by steps left from the bar code.

  • Page 7: Settings For Interleaved 2 Of 5

    COBISS System Management Datalogic Heron HD3130User Guide Enable CODE 93: → Code93 = Enable Exit Programming Mode and save → parameters When restoring the reader to the EU factory settings, CODE 93 is not set. In the following step, enable CODE 93. Other factory settings correspond to the use of the reader in the COBISS system.

  • Page 8: Additional Settings For Led Indicator

    Datalogic Heron HD3130User Guide COBISS System Management Exit Programming Mode and save parameters → * Perform step 4 only when the Interleaved 2 of 5 bar code number is uneven. Otherwise, go to step 5. Additional Settings for LED Indicator Enter Programming Mode→...

  • Page 9: Additional Settings For Speaker Volume

    COBISS System Management Datalogic Heron HD3130User Guide Additional Settings for Speaker Volume Enter Programming Mode→ Good Read Speeker Volume: → GRBV = Low Good Read Speeker Volume: → GRBV = Medium Good Read Speeker Volume: → GRBV = High Exit Programming Mode and save →...

  • Page 10: Testing Parameters

    Datalogic Heron HD3130User Guide COBISS System Management Testing Parameters You can test if the parameters were set up successfully by using the following test bar codes: COBISS Additional bar codes CODE 93 Brez kontrolnega znaka (4)! © IZUM, 7 July...

Table of Contents