Advertisement
Installation Guide
Motorized Rolling Stand
MT02E
Important
To ensure proper installation, follow the
steps and safety precautions in this
document. The rolling stand can support
a maximum weight of 120 kg (264 lbs).
The recommended display sizes for this
stand range from 55" to 86". Mounting
other equipment on the stand may result
in damages and injuries.
v 1.00
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BenQ MT02E
Summary of Contents for BenQ MT02E
- Page 1 120 kg (264 lbs). The recommended display sizes for this stand range from 55" to 86". Mounting other equipment on the stand may result in damages and injuries. Installation Guide Motorized Rolling Stand MT02E v 1.00...
-
Page 2: Safety Information
Safety information Important safety information for installers and users Safety note for installers Before installation, carefully read the safety information and relevant procedures in this document. Failure to read, thoroughly understand, and follow all the instructions in this document can result in serious personal injury and damage to the equipment. -
Page 3: Package Contents
Package contents Component Quantity Component Quantity Caster wheel Power cord Base Power extender cable Lifting column Spring cable bracket Mounting frame Spring cable Mounting bracket Component Quantity Component Quantity #5 hex wrench M8 × 25 mm screw 13 mm washer M4 ×... -
Page 4: Installation
Important To prevent serious physical injuries and damage to the unit, ensure the following: • The stand and display are installed by at least two qualified technicians. BenQ accepts no liability for installations not performed by a professional technician. •... - Page 5 e. Place the assembled base in an upright position. 3. Install the mounting frame. a. Lock the wheels in place. b. Carefully place the mounting frame (D) on top of the lifting columns (C). Ensure that the front of the frame and the longer side of the base are facing the same direction. c.
- Page 6 4. Connect the motor cables. a. Remove the panel cover screws from the back of the mounting frame (D), and then lift the panel cover. b. Connect the cables of the lifting columns (C) with the cables of the frame. c.
- Page 7 5. Install the mounting brackets. a. Place padding on a flat, horizontal, and object-free surface. Important • Ensure that the padding is clean, soft, and dry to prevent leaving marks on the screen. • Ensure that the size of the padding is larger than the display. b.
- Page 8 7. Install the spring cable. a. Align the holes of the spring cable (I) with the holes at the back of the mounting frame. b. Attach the M4 × 6 mm screws (O). c. Ensure that the spring cable is securely attached to the frame. 8.
- Page 9 9. Secure the spring cable on the column. a. Place the spring cable bracket (H) on the column. b. Insert the pin at the base of the spring cable into the notch of the bracket. c. Rotate the base of the spring cable until both the screw holes are aligned. d.
-
Page 10: Power Consumption
If the rebound height is 50 mm, perform another forced reset until the rebound height is 7 mm. Power consumption The MT02E motorized rolling stand consumes less than 0.5W while on standby. It automatically enters standby mode after 2 minutes of inactivity.
Need help?
Do you have a question about the MT02E and is the answer not in the manual?
Questions and answers