Advertisement
Configuring LapLink for Windows
Before using LapLink on your Versa 4200 system using the Windows 98
operating system, you must edit the LapLink.ini file and configure LapLink's
Port Setup.
Edit the LapLink.ini file as follows.
1. Use notepad to open C:\windows\tsi32\laplink\llw\llw.ini.
2. Under the [COM2] heading, set "UseIRDADriver" to No.
3. Under the [COM4] heading, set "USEIRDADriver" to Yes.
Configure Laplink's Port Setup as follows.
1. Go to Start, Programs, Laplink for Windows, and select Laplink for
Windows. If this is the first time that you are configuring Laplink you will
receive a dialog box to run port setup. If so, click Yes to run port setup.
2. Click the Options menu and select Port Setup to display the Port Settings
window.
3. Click the COM2 entry to highlight. Use the dropdown menu to set the type
to wireless. Be sure that the Enable Port box is unchecked.
4. Click the COM4 entry to highlight. Use the dropdown menu to set the type
to wireless. Be sure that the Enable Port box is checked.
NEC Versa 4200 Windows 98 Upgrade Information 5
NEC Versa 4200
Windows 98 Upgrade Information
819-200543-000 Rev. 00
8/98
Advertisement
