System Requirements; Disabling Save-To-Disk In The Bios Setup - NEC VERSA 4200 WINDOWS 98 - UPGRADE INFORMATION Manual

System Requirements

The system requirements for your NEC Versa using Windows 98 are
approximately the same as they are for using Windows 95. As with Windows
95, Windows 98 requires 16 MB of RAM. For hard disk space, a typical
installation requires 225 MB of free hard disk space, but may range from 165
MB to 300 MB, depending on system configuration and options selected.
The system requirements for your NEC Versa are:
T
A minimum of 16MB of RAM.
T
Approximately 50 MB additional hard disk capacity.
T
If backing up Windows 95 system configuration files, another additional
50 MB for a total of 100-MB additional hard disk space.
your system has insufficient hard drive space to proceed.
NEC recommends that you do the following procedures in the order listed to
upgrade your system.
1. Disable the "Save-to Disk" feature in the BIOS setup.
2. Upgrade your operating system to Windows 98.
3. Upgrade your mouse driver.
4. Configure LapLink for Windows.

Disabling Save-to-Disk in the BIOS Setup

Follow these steps to disable "Save-to-Disk" in the BIOS setup.
1. Boot the system and enter the BIOS setup utility by pressing the F2 key, as
indicated on the screen, before Windows is loaded.
2. Once the BIOS setup utility appears, press the right arrow key 3 times in
order to display the "Power Savings" menu.
3. Press the down arrow to select the "Suspend Mode" row entry.
4. Press the plus ('+') to change the "Suspend Mode" setting to "Suspend" if it
is set to "Save to Disk." (The default setting is "Suspend.")
5. Press the down arrow to select the "Auto Save To File" row entry.
6. Press the plus ('+') to change the "On" setting to "Off."
7. Press the right arrow key once to display the "Exit" menu.
8. Highlight "Save Changes and Exit" if it is not already selected.
2 NEC Versa 4200 Windows 98 Upgrade Information
Note:
The Windows 98 Setup Wizard informs you if