Delivery; Storage; Pump Returning Back To The Supplier; Intended Use - Wilo Atmos ISO FF 100-200 Installation And Operating Instructions Manual

3.2 Delivery

On arrival, the delivered items must be inspected for
damage and a check made that all parts are present. If any
parts are damaged or missing, the transport company or
the manufacturer must be informed on the day of delivery.
Any claim made later will be deemed invalid. Damage to
parts must be noted on the delivery or freight
documentation.

3.3 Storage

3.3.1 Short-term storage (less than 3 month)
The equipment as shipped have adequate protection for
short-term storage in a covered, dry, and ventilated
location at the job site prior to installation.
• If the pump is not installed immediately after delivery, it
must be stored in a dry and clean place with sufficient
ventilation, no vibration, no freezing, and the temperature
variations must be smooth.
• Bearings and couplings must be protected against sand,
dust, and foreign bodies. To avoid corrosion and jamming,
please lubricate the pump and make turn the rotating
elements for several turns at least once a week.
• Pre-packed desiccants may be used to absorb moisture &
keep the pump dry. It must be removed before putting the
pump on operation.
3.3.2 Long-term storage (more than 3 month)
If the equipment will be subject to extended storage
condition prior to installation, then the manufacturer must
be informed about storage duration, so that special
protection can be recommended.
• Place the Atmos ISO FF pumps horizontally on firm
foundation and secure it against falling.
• The machine must be protected from direct sunlight, heat,
dust, and frost.
• The rotors or propellers must be turned at regular intervals.
This prevents the bearing from locking.
3.4 Pump returning to the supplier.
Products, which are delivered back to the plant, must be
clean and correctly packaged. In this context, clean means
that impurities have been removed and decontaminated if
it has been used with materials, which are hazardous to
health.
The packaging must protect the product against damage.
CAUTION! Guarantee not applicable!
Products, which are not suitably packaged for delivery
back, are no longer covered by guarantee!
4 Intended uses
The pump supplied is intended for specific fluid. Refer pump
data sheet and order confirmation. For any change in
pumped fluid refer WILO Mather and Platt beforehand.
Atmos ISO FF pumps are used in water supply, water-
circulating systems and process, injection water, spray pond,
air-conditioning, water treatment, Sprinkler & drip irrigation,
firefighting, etc. If the operating conditions are different of
the specifications given in the order, (i.e., type of liquid,
temperature, or duty point), the end user must ask a written
agreement to WILO Mather and Platt on the new operating
conditions before starting the pump.
Installation and operating instructions WILO Mather and Platt – Atmos ISO FF Pumps
4.1 Service Life
10 years depending on operating conditions and the
fulfillment of all operating manual requirements.

5 Product information

5.1 Data plate

Date of manufacturing is marked on the name plate.
Explanation is as follows:
MM/YY = 01/2020
MM = Month of manufacturing
YY = Year of manufacturing
11